GE Monogram GXSF30H installation instructions Safety Precautions

Page 2

IMPORTANT SAFETY INFORMATION.

READ ALL INSTRUCTIONS BEFORE USING.

WARNING!

For your safety, the information in this manual must be followed to minimize the risk of electric shock, property damage or personal injury.

SAFETY PRECAUTIONS

Check and comply with your state and local codes. You must follow these guidelines.

Use care when handling the water softening system. Do not turn upside down, drop, drag or set on sharp protrusions.

Water softening systems using sodium chloride (salt) for recharge add sodium to the water.

Persons on sodium restricted diets should consider the added sodium as part of their overall intake. Potassium chloride can be used as an alternative to sodium chloride in your softener.

The water softening system works on 24 volt-60 Hz electrical power only. Be sure to use only the included transformer.

Transformer must be plugged into an indoor 120 volt, grounded outlet only.

Use clean water softening salts only, at least 99.5% pure. NUGGET, PELLET or coarse SOLAR salts are recommended. Do not use rock, block, granulated or ice cream making salts. They contain dirt and sediments, or mush and cake, and will create maintenance problems.

Keep the salt hole cover in place on the softener unless servicing the unit or refilling with salt.

WARNING: Do not use with water that is microbiologically unsafe or of unknown quality without adequate disinfection before or after the system.

PROPER INSTALLATION

This water softening system must be properly installed and located in accordance with the Installation Instructions before it is used.

Install or store where it will not be exposed to temperatures below freezing or exposed to any type of weather. Water freezing in the system will break it. Do not attempt to treat water over 100°F.

Do not install in direct sunlight. Excessive sun or heat may cause distortion or other damage to non-metallic parts.

Properly ground to conform with all governing codes and ordinances.

Use only lead-free solder and flux for all sweat- solder connections, as required by state and federal codes.

The water softening system requires a minimum water flow of three gallons per minute at the inlet. Maximum allowable inlet water pressure is 125 psi. If daytime pressure is over 80 psi, nighttime pressure may exceed the maximum. Use a pressure reducing valve to reduce the flow if necessary.

Softener resins may degrade in the presence of chlorine above 1 ppm. If you have chlorine in excess of this amount, you may experience reduced life of the resin. In these conditions, you may wish to consider purchasing a GE point-of-entry household filtration system with a chlorine reducing filter.

WARNING: Discard all unused parts and packaging material after installation. Small parts remaining after the installation could be a choke hazard.

READ AND FOLLOW THIS SAFETY INFORMATION CAREFULLY.

SAVE THESE INSTRUCTIONS

2

Image 2
Contents 7277886 215C1173P016 49-50160-108-05 JR Write the model and serial numbers here Model # Serial #Safety Precautions Unpacking and Inspection Installation instructionsImportant Installation Recommendations Tools and Materials Required for Installation Plan How You Will Install the SoftenerWhere to Install the Softener Typical Installation Illustration Optional 3-Valve Bypass Installation IllustrationMove the Softener Assembly Into Installation Position Step-by-step installation instructionsInstall Bypass Valve Plumb in and OUT Pipes to and from SoftenerInstall Grounding Clamp 4A. Connecting a Rigid Valve Drain TubeInstall the Brine Tank Overflow Fittings and Hose Connect to Electrical PowerSET Water Hardness Number Programming the ControlSET Present Time of DAY SET Recharge Starting TimeSYSTEM/ELECTRONIC Diagnostics Optional Control SettingsError Signals Salt EfficiencySanitizing Procedures Specifications/DimensionsAbout the water softener system Do not overtighten the cap Cleaning the Nozzle and Venturi AssemblyBreaking a Salt Bridge Feature/Service Automatic Electronic Diagnostics Feature Optional Recharge ControlsFeature Memory Normal Operation, Control DisplaysPossible Defect Service Electronic Demand Time Features and ServiceService Timer/Softener, Service Checkout Procedure Visual ChecksIf the code was changed, make ALL the timer settings Open a Nearby Soft Water FaucetIf the water softening system does not draw brine, check Checking the Salt Storage Level and Refilling Care and cleaning of the water softening systemCleaning Iron Out of the Water Softening System However, you must keep the tank supplied with saltThat does not mix soft and hard water Before you call for service…Problem Possible Causes What To Do No soft water Water feels slippery After installationNot using any salt Water softening systemBrown/yellow Brown/yellow colored Water after installationSalty tasting or Colored water Resin beads showingGEAppliances.com Parts list GEAppliances.com Parts catalog General Electric Parts CatalogSupport Screen Warrantor General Electric Company. Louisville, KY What Is Not CoveredFor The Period Of We Will Replace GE Water Softening System Warranty. For Customers in Canada For The Period We Will ReplacePage Información de seguridad Instrucciones para la Advertencia Advertencia No use con agua queDesempacado e inspección Instrucciones de instalaciónAdvertencia No use con Recomendaciones importantes para la instalaciónHerramientas y materiales necesarios para la instalación Planifique la instalación del DescalcificadorDónde instalar el Descalcificador Ilustración de instalación normal PrincipalInstrucciones de instalación paso por paso Instale LA Válvula DE BypassDE LA Válvula 4A. Cómo Conectar UN Tubo DE Drenaje DE Válvula RígidaConecte EL Suministro Eléctrico Instale LA Abrazadera DE TierraAgregue Agua Y SAL AL Tanque DE Salmuera Ajuste EL Nivel DE Dureza DEL Agua Programación del controlAjuste LA Hora DEL DÍA Ajuste LA Hora DE Inicio DE RecargaDiagnóstico ELECTRÓNICO/DEL Sistema Señales DE ErrorAjustes opcionales de control Eficiencia DE LA SALEspecificaciones/Dimensiones Procedimientos de desinfecciónSobre el sistema de descalcificación de agua Cómo romper un puente de sal Cómo limpiar la ensambladura de la boquilla y el Venturi Junta Tapón de flujoCaracterística/Servicio Diagnóstico electrónico automático Operación normal, Pantalla de controlFunción Memoria Recargue Esta NocheVisualizado Inspecciones VisualesServicio Diagnóstico electrónico iniciado manualmente Servicio Inspección manual del avance de la racarga Recharge recargoPrecaución No HAY Agua DESCALCIFICADA-Problemas más comunes Antes de llamar para solicitar servicio…Veces el agua El agua sabe a sal o tiene Notas Notas Notas Lista de partes 146 999GEAppliances.com Catálogo de partes Catálogo DE Partes DE General ElectricPASADOR, Expansión Lo que no está cubierto Garantía GE para el Sistema de Descalcificación de AguaPor el período de Reemplazamos Garante General Electric Company. Louisville, KYGarantías ampliadas Soporte al Consumidor Página Web de GE AppliancesSolicite una reparación Piezas y accesoriosConsumer Support GE Appliances Website Schedule ServiceParts and Accessories Real Life Design Studio

GXSF30H specifications

The GE Monogram GXSF30H is a sophisticated and stylish refrigerator that epitomizes luxury and advanced technology in kitchen appliances. Designed with the modern homeowner in mind, this appliance combines elegance with functionality to enhance any kitchen space.

One of the standout features of the GXSF30H is its spacious interior, which boasts an impressive capacity, allowing homeowners to store a significant amount of food and beverages. The adjustable shelves provide versatility, accommodating various items from tall bottles to small containers, making organization a breeze.

The refrigerator's exterior is finished with high-quality stainless steel, giving it a sleek and contemporary look that complements any kitchen decor. It also features a built-in water and ice dispenser, providing easy access to chilled water and crushed or cubed ice at the touch of a button. This convenience is enhanced by the advanced filtration system, which ensures that the water is not only cold but also clean and great-tasting.

The GXSF30H is equipped with a state-of-the-art cooling system that maintains optimal temperatures. Utilizing dual climate control technology, it regulates the refrigerator and freezer temperatures independently, ensuring that perishable items stay fresh longer. Additionally, this model incorporates advanced humidity control features that help keep fruits and vegetables at their peak freshness.

Energy efficiency is another hallmark of the GE Monogram GXSF30H. It is designed with Energy Star certification, signifying that it meets strict energy efficiency guidelines. This not only helps reduce electricity bills but also minimizes environmental impact, making it a responsible choice for eco-conscious consumers.

Furthermore, the GXSF30H integrates smart technology, allowing users to control and monitor their refrigerator remotely via a smartphone app. This innovative feature enables users to adjust settings, receive alerts, and track food inventory, making it an ideal solution for today’s on-the-go lifestyle.

In summary, the GE Monogram GXSF30H refrigerator is a remarkable blend of elegant design, ample storage, cutting-edge technology, and energy efficiency. Its combination of features, such as customizable organization, advanced cooling technology, and smart connectivity, makes it a top choice for anyone looking to elevate their kitchen experience. Whether you're hosting a dinner party or managing a busy family schedule, this refrigerator is designed to meet your needs while exuding sophistication and style.