GE Monogram GXSF30H Before you call for service…, That does not mix soft and hard water

Page 18

Before you call for service…

Troubleshooting Tips

Save time and money! Review the charts on the following pages first and you may not need to call for service.

NO SOFT WATER—Most Common Problems:

Check the following before calling for service:

Not enough salt—should be at least 1/3 full.

Bypass valve in “Bypass” position—knob should be in the “OUT” (service) position.

Hardness setting too low. Check hardness setting and adjust. Verify hardness of supply water—from local water company, water test or call the GE Answer Center.

Salt Bridge—salt solidifies above water level so that brine water is not in contact with salt. See the Breaking a Salt Bridge section.

Problem

Possible Causes

What To Do

No soft water

Faucet or fixture where sample was

To conserve salt, the installer may have isolated some fixtures

 

taken not plumbed to soft water

(outside faucets, toilets, etc.) from soft water. From the outlet

 

NOTE: Be sure sample is from a faucet

of the water softening system, trace the water flow path,

 

that does not mix soft and hard water.

in house plumbing. If soft water is not directed to a faucet

 

For example, a single lever kitchen faucet,

or fixture where wanted, consult a plumber.

 

if the cold side is plumbed to hard water.

 

No salt in the brine tank or salt bridged

Check for a salt bridge or, if the tank is empty, refill with recommended salt. Press (for 3 seconds) the RECHARGE button to start an immediate recharge and restore

soft water supply.

Transformer unplugged at wall outlet or power cable to softener not connected. Fuse blown or circuit breaker popped on circuit to electrical outlet.

Electrical outlet on a circuit that can be switched off

Check for a loss of electrical power to the water softening system, due to any of these conditions and correct as needed. With the power supply restored, observe the faceplate time display and read Programming the Control section.

NOTE: The electrical outlet for the softener should be continuously live so it cannot be accidentally switched off.

Manual bypass valve in bypass position Be sure the bypass valve stem is positioned properly, with the knob in the OUT position. Observe instructions on the decal at the end of the stem.

Valve drain hose pinched, plugged, elevated too high or otherwise restricted

Any restriction in this drain hose may prevent proper operation of the nozzle and venturi and reduce or prevent brine draw during recharge.

Nozzle and venturi dirty, incorrectly assembled or damaged

Refer to Cleaning the Nozzle and Venturi Assembly instructions. With water pressure to the water softening system off, take the nozzle assembly apart. Inspect, clean and replace as needed. Any foreign particle(s), scratches, nicks, etc., in the passages can prevent operation. Be sure holes in the gasket are centered over holes in the housing.

18

Image 18
Contents 7277886 215C1173P016 49-50160-108-05 JR Write the model and serial numbers here Model # Serial #Safety Precautions Installation instructions Important Installation RecommendationsUnpacking and Inspection Plan How You Will Install the Softener Where to Install the SoftenerTools and Materials Required for Installation Typical Installation Illustration Optional 3-Valve Bypass Installation IllustrationMove the Softener Assembly Into Installation Position Step-by-step installation instructionsInstall Bypass Valve Plumb in and OUT Pipes to and from SoftenerInstall Grounding Clamp 4A. Connecting a Rigid Valve Drain TubeInstall the Brine Tank Overflow Fittings and Hose Connect to Electrical PowerSET Water Hardness Number Programming the ControlSET Present Time of DAY SET Recharge Starting TimeSYSTEM/ELECTRONIC Diagnostics Optional Control SettingsError Signals Salt EfficiencySanitizing Procedures Specifications/DimensionsAbout the water softener system Cleaning the Nozzle and Venturi Assembly Breaking a Salt BridgeDo not overtighten the cap Feature/Service Automatic Electronic Diagnostics Feature Optional Recharge ControlsFeature Memory Normal Operation, Control DisplaysPossible Defect Service Electronic Demand Time Features and ServiceService Timer/Softener, Service Checkout Procedure Visual ChecksIf the code was changed, make ALL the timer settings Open a Nearby Soft Water FaucetIf the water softening system does not draw brine, check Checking the Salt Storage Level and Refilling Care and cleaning of the water softening systemCleaning Iron Out of the Water Softening System However, you must keep the tank supplied with saltBefore you call for service… Problem Possible Causes What To Do No soft waterThat does not mix soft and hard water Water feels slippery After installationNot using any salt Water softening systemBrown/yellow Brown/yellow colored Water after installationSalty tasting or Colored water Resin beads showingGEAppliances.com Parts list GEAppliances.com Parts catalog General Electric Parts CatalogSupport Screen What Is Not Covered For The Period Of We Will ReplaceWarrantor General Electric Company. Louisville, KY GE Water Softening System Warranty. For Customers in Canada For The Period We Will ReplacePage Información de seguridad Instrucciones para la Advertencia Advertencia No use con agua queDesempacado e inspección Instrucciones de instalaciónAdvertencia No use con Recomendaciones importantes para la instalaciónPlanifique la instalación del Descalcificador Dónde instalar el DescalcificadorHerramientas y materiales necesarios para la instalación Ilustración de instalación normal PrincipalInstrucciones de instalación paso por paso Instale LA Válvula DE BypassDE LA Válvula 4A. Cómo Conectar UN Tubo DE Drenaje DE Válvula RígidaInstale LA Abrazadera DE Tierra Agregue Agua Y SAL AL Tanque DE SalmueraConecte EL Suministro Eléctrico Ajuste EL Nivel DE Dureza DEL Agua Programación del controlAjuste LA Hora DEL DÍA Ajuste LA Hora DE Inicio DE RecargaDiagnóstico ELECTRÓNICO/DEL Sistema Señales DE ErrorAjustes opcionales de control Eficiencia DE LA SALEspecificaciones/Dimensiones Procedimientos de desinfecciónSobre el sistema de descalcificación de agua Cómo romper un puente de sal Cómo limpiar la ensambladura de la boquilla y el Venturi Junta Tapón de flujoCaracterística/Servicio Diagnóstico electrónico automático Operación normal, Pantalla de controlFunción Memoria Recargue Esta NocheVisualizado Inspecciones VisualesServicio Diagnóstico electrónico iniciado manualmente Servicio Inspección manual del avance de la racarga Recharge recargoPrecaución No HAY Agua DESCALCIFICADA-Problemas más comunes Antes de llamar para solicitar servicio…Veces el agua El agua sabe a sal o tiene Notas Notas Notas Lista de partes 146 999GEAppliances.com Catálogo de partes Catálogo DE Partes DE General ElectricPASADOR, Expansión Lo que no está cubierto Garantía GE para el Sistema de Descalcificación de AguaPor el período de Reemplazamos Garante General Electric Company. Louisville, KYGarantías ampliadas Soporte al Consumidor Página Web de GE AppliancesSolicite una reparación Piezas y accesoriosConsumer Support GE Appliances Website Schedule ServiceParts and Accessories Real Life Design Studio

GXSF30H specifications

The GE Monogram GXSF30H is a sophisticated and stylish refrigerator that epitomizes luxury and advanced technology in kitchen appliances. Designed with the modern homeowner in mind, this appliance combines elegance with functionality to enhance any kitchen space.

One of the standout features of the GXSF30H is its spacious interior, which boasts an impressive capacity, allowing homeowners to store a significant amount of food and beverages. The adjustable shelves provide versatility, accommodating various items from tall bottles to small containers, making organization a breeze.

The refrigerator's exterior is finished with high-quality stainless steel, giving it a sleek and contemporary look that complements any kitchen decor. It also features a built-in water and ice dispenser, providing easy access to chilled water and crushed or cubed ice at the touch of a button. This convenience is enhanced by the advanced filtration system, which ensures that the water is not only cold but also clean and great-tasting.

The GXSF30H is equipped with a state-of-the-art cooling system that maintains optimal temperatures. Utilizing dual climate control technology, it regulates the refrigerator and freezer temperatures independently, ensuring that perishable items stay fresh longer. Additionally, this model incorporates advanced humidity control features that help keep fruits and vegetables at their peak freshness.

Energy efficiency is another hallmark of the GE Monogram GXSF30H. It is designed with Energy Star certification, signifying that it meets strict energy efficiency guidelines. This not only helps reduce electricity bills but also minimizes environmental impact, making it a responsible choice for eco-conscious consumers.

Furthermore, the GXSF30H integrates smart technology, allowing users to control and monitor their refrigerator remotely via a smartphone app. This innovative feature enables users to adjust settings, receive alerts, and track food inventory, making it an ideal solution for today’s on-the-go lifestyle.

In summary, the GE Monogram GXSF30H refrigerator is a remarkable blend of elegant design, ample storage, cutting-edge technology, and energy efficiency. Its combination of features, such as customizable organization, advanced cooling technology, and smart connectivity, makes it a top choice for anyone looking to elevate their kitchen experience. Whether you're hosting a dinner party or managing a busy family schedule, this refrigerator is designed to meet your needs while exuding sophistication and style.