About the water softener system.
Service: Electronic Demand Time Features and Service
ERROR CODE DISPLAYED | ERR 01 | ERR 02 | ERR 03 | ERR 04 | ERR 05 |
|
|
|
|
|
|
POSSIBLE DEFECT | • Motor | • Position | • Motor | • Position | • Control |
| inoperative | switch | inoperative | switch or |
|
|
|
| or wiring | wiring |
|
|
|
| harness | harness |
|
| • Wiring harness | • Control | • Control | • Control |
|
| or connection |
|
|
|
|
| to switch |
|
|
|
|
| • Position switch |
|
|
|
|
| • Control |
|
|
|
|
|
|
|
|
|
|
To remove an error code: 1. Unplug transformer.
2.Correct defect.
3.Plug transformer in.
4.Wait for at least 6 minutes. The error code will return if the reason for the error code was not corrected.
Service: Timer/Softener, Service Checkout Procedure
If you are not getting soft water, and an error code is not displayed, use the procedures below to find the problem. First make the following visual checks.
VISUAL CHECKS:
1.Is there electrical power to the outlet the water softening system transformer is plugged into?
2.Is there sufficient salt in the storage tank?
3.Is the softener bypass valve directing water for soft water service?
4.Is the valve drain hose open to the drain, not more than 8′ above the softener, and unobstructed? If hose is above 8′, see page 6, section 4.
If you do not find a problem with the visual checks, continue below.
NO SOFT
WATER
CONTROL SHOWS WRONG TIME AND DAY, AND/OR IS FLASHING.
Electrical power was off. Reset the correct time of day.
Investigate reason for power loss.
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| Check electrical |
|
|
| ||||
|
| CONTROL |
|
|
| power to control |
|
|
| ||||
|
| DISPLAY |
|
|
| (outlet, transformer, |
|
|
| ||||
|
| BLANK. |
|
|
| power cable, all |
|
|
| ||||
|
|
|
|
|
| connections). |
|
|
| ||||
|
|
|
| ||||||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
CONTROL DISPLAY SHOWS |
|
|
|
|
|
|
| ||||||
|
|
| Do manual |
| |||||||||
CORRECT TIME AND DAY |
|
|
|
| |||||||||
|
|
|
| ||||||||||
AND IS STEADY. |
|
|
|
|
|
|
| diagnostics. |
| ||||
|
|
|
|
|
|
|
|
|
|
| |||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
NO POWER 
POWER OK 
REPAIR AS NEEDED
CONTROL DEFECTIVE
Do manual diagnostics to verify proper function.
14