Installation | Tools and materials | ● | 1/4” nutdriver | |||
Step7 | required: |
| ●5/16° nutdriver | |||
● Measuring | tape | ● 7/16“ | and 5/16” socket and | |||
| ● Pencil |
|
| ratchet | wrench | |
Halogm/Radiant |
|
| ● #2 Phillips screwdriver bit | |||
I$&’~eSivegasketStrip | socket |
| ||||
cookt+, updra~ | - |
|
|
| ||
|
| Philiips | screwdriver | |||
grz”lland | (supplied) |
| ● | |||
If installing a downdraft grill cooktop and blower that | ||||||
doumdrafip”ll | ||||||
requires reorientation and/or relocation, refer to | ||||||
| ||||||
| “ReOtient | Blowern and | “Relocate | Blower”. |
Installation
Component Cooking Surfaces
●Flanged joiner nurs (supplied)
QTwo
●
●
●Clean towel
Gas cookt~
Tools and materials
required:
●
●Measuring tape
●Pencil
●Scissors
●Flanged joiner nuts (supplied)
●Two
●1/4” nutdriver
●Gas pressure regulator (supplied)
●
●Saw
●Carpenter’s square
●Pipe wrench
●3/4” NPT x 3/4” I.D. or 1/2” NPT x 1/2” I.D. flare union adaptor
●1/2” NPT x 3/4” I.D. or
1/2” I.D. flare union adaptor
●
●5 foot
-If required by local codes, use solid pipe with fittings as required.
A@lj gasketstrip
Remove knobs and tm”m
Llagfam 501
. Apply foam tape (provided) on top surface of counter- top precisely along edge of cutout on all four sides.
“Turn all control knobs to OFF position.
. Carefully remove cooktop and downdraft vent
component control knobs by lifting (with fingers only)
Note: To prevent scratching
straight up.
. Remove all grates, burner caps and vent covers from knobs, remove them from unit before it is turned face down.
components,
50