7Installation (continued)
Step
Jo~nW
cooktq ~“
downdrafi
vent
Installation
Component Cooking Surfaces
Note: To prevent knobs being
scratched, knobs must be
removed from component before
it is turned upside down.
D/agram521
. Remove all grates, knobs, burner caps, drip pans, etc.
“Lay cooktop upside down on soft, clean towel on a large work surface.
s Remove endcap on side ofcooktop to bejoined by removing three nuts with 5/ 16“ nutdnver. Discard nuts.
Important:
- Replace endcap with downdraftjoiner strip using the same three nuts.
“ Attach downdraft endcap to appropriate side of downdraft vent if vent is at end of a cooktop run.
- Place downdraft vent and cooktop in countertop cutout.
“Attach one downdraft vent housing support brace
to front of unit.
. Remove two screws from front of cooktop chassis.
. Put brace in place on cooktop first, using two removed screws. Thread a similar screw, provided, through plenum.
. Drive two
. If downdraft vent is installed at end of configuration, secure downdraft endcap by driving two Phillips head screws, as shown.
. To finalize installation, proceed to “Securing cooktop(s) to countertop. ”
-If additional cooktop(s) are to be installed, proceed to “Joining additional cooktop to other side of downdraft vent. ”
%)
i
D/agram522
-
Q
Diagram 523
Front of Countertop
Downdraft Endcap
D:agram524
52