3M 39600 manual Bumper Supports

Installation and Set-Up (Continued)

BUMPER SUPPORTS (Upper Drive Assembly)

Raise and lock the upper drive assembly into its raised position. See "Operation – Mechanical Latch", page 18.

Install the two bumper supports, one on each side column using lower holes in bracket as shown in Figure 2-6. (The upper set of holes allows the upper drive assembly to return to a lower position. However, this minimum position can only be used if the taping heads are adjusted to apply 50 mm

[2 inch] long tape legs.)

Note –Interference and damage to the taping heads may occur if the upper mounting bracket holes are used with the taping heads at the standard setting (70 mm [2.75 inch] tape legs).

Figure 2-6 – Bumper Supports

BOX SIZE CAPACITY OF CASE SEALER

At its factory setting, the case sealer handles box sizes up to 620 mm [24.5 inch] maximum height. If larger capacity is needed, the machine can be adjusted to accommodate boxes up to 725 mm [28.5 inch] high. Refer to "Special Set- Up Procedure – Box and Machine Bed Height Range", page 31. Note – Adjusting machine to accommodate 725 mm [28.5 inch] high boxes also increases minimum box size to 170 mm [6.8 inch].

ELECTRICAL CONNECTION AND CONTROLS

The electrical control box and "On/Off" switch are located on the lower left side of the machine frame. See Figure 3-1. If desired, for operator convenience, the "On/Off" switch can be relocated to the right side of the machine frame. A standard three conductor power cord with plug is provided at the back of the electrical control box for 115 Volt, 60 Hz., 3.8 Amp electrical service. The receptacle providing this service shall be properly grounded. Before the power cord is plugged into 115 Volt, 60 Hz outlet make sure that all packaging materials and tools are removed from the machine. Do not plug electrical cord into outlet until ready to run machine.

Use of an extension cord is not recommended. However, if one is needed for temporary use, it must have a wire size of 1.5 mm diameter [AWG 16 ], have a maximum length of 30.5 m [100 ft], and must be properly grounded.

WARNING – To prevent shock and fire hazard: Position extension

cord where it will be out of the way of foot or vehicle traffic. Extension cord is only for temporary use – do not use for a permanent installation.

Note –Machines outside the U.S. may be equipped with 220/240 Volt, 50 Hz systems or other electrical requirements compatible with local practice.

INITIAL START-UP OF CASE SEALER

After completing the "Installation and Set-Up" procedure, continue through "Operation" for tape loading and start-up to be sure case sealer is properly adjusted to run boxes

14