Installation and Set-Up (Continued)
13.Use appropriate material handling equipment to remove the machine from the pallet and move it into position.
Whenever the machine is lifted with a fork truck, insure that the forks span completely across the machine frame and do not contact any wiring or mechanism under the machine frame. In some cases the lower taping head may need to be removed to avoid damage.
CAUTION – Machine weighs approximately 200 kg [430 pounds]
uncrated.
14.Continue with the remainder of the Installation and
INFEED CONVEYOR ASSEMBLY
1.Remove the conveyor and the package of parts from the carton.
2.Verify that the package contains two right angled cover plates, twelve M8 x 15 hex head screws, and eight M8 flat washers.
3.To assemble the infeed conveyor, refer to Figure
4.Insert a M8 x 15 screw in each hole so that only a few threads take hold. Do not use washers with these screws.
5.Attach the infeed conveyor over the screws using the inverted keyholes in the end of the conveyor. Tighten all four screws with a 13 mm wrench.
6.Refer to Figure
CENTERING GUIDES
1.Remove the two centering guides and four
M6 x 20 socket head screws from the package.
2.Using a 5 mm hex key wrench, attach the centering guides to the rails with four M6 x 20 screws (two in each guide) as shown in Figure
Figure 2-2 – Infeed Conveyor
Figure 2-3 – Cover Plates
Figure 2-4 – Centering Guides
12