Operation (Continued)
WARNINGS
1.Turn electrical and air supply off and disconnect before servicing taping heads or performing any adjustments or maintenance on the machine.
2.Do not leave machine running unattended.
3.Before turning drive belts on, be sure no tools or other objects are on the machine bed.
4.Keep hands and loose clothing away from moving belts.
5.Keep hands and clothing away from taping heads when machine is running. A box traveling through the machine causes taping head rollers to retract when box enters and extend as box leaves taping head.
6.Never attempt to work on any part of the machine, load tape or remove jammed boxes from the machine while machine is running.
7.Be aware of the pneumatically controlled movement of the upper assembly and box centering guides. Keep away from these components when air and electrical supplies are on.
8.When feeding boxes to the machine by hand, push box in from end only – DO NOT PUSH WITH HANDS ON ANY CORNER OF THE BOX.
9.Do not put hands beneath upper drive assembly when upper drive assembly lowers to its rest position.
10.Both the upper and lower taping heads utilize extremely sharp knives. The knives are located under the orange knife guard which has the 'WARNING – SHARP KNIFE" label. Before loading tape, refer to Figures
11.Turn electrical and air supply off when machine is not in use.
12.Failure to comply with these warnings could result in severe personal injury and/or equipment damage.
Tape Loading/Threading
See Section II, Pages 7 and 8
Note
CAUTION – Taping head weighs approximately 7.2 kg [16 pounds]
without tape. Use proper body mechanics when removing or installing taping head.
19