Miele KM 5940, KM 5950 installation instructions Safety instructions for installation

Page 34

Safety instructions for installation

The appliance must only be installed and connected to the electricity supply by a suitably qualified and competent person in strict accordance with current national and local safety regulations

(BS 7671 in the UK).

Fit the wall units and extractor hood before fitting the hob to avoid damaging the appliance.

￿The veneer or laminate coatings of worktops (or adjacent kitchen units) must be treated with 100 °C heat-resistant adhesive which will not dissolve or distort.

Any backmoulds must be of heat-resistant material.

￿This equipment may only be used in mobile installations such as ships, if a risk assessment has been carried out by a suitably qualified engineer.

￿The hob may not be built in over a fridge, fridge freezer, freezer, dishwasher, washing machine or tumble dryer.

￿This hob must not be installed above an oven or cooker unless this has built-in cooling down fan.

￿After installing the hob, ensure that the connection cable cannot come into contact with the underside of the appliance. Make sure that there is no mechanical obstruction, such as a drawer, which could damage it.

￿Observe carefully the safety distances given on the following pages.

All dimensions in this instruction booklet are given in mm.

34

Image 34
Contents En GB Contents Installation General installation tips Guide to the appliance Guide to the appliance Control panel Sensor switches forCooking zone display Cooking zone Cooking zonesRating in watts for 230 Correct application Safety with children Technical safety Correct use Page Page Disposal of the packing material Caring for the environmentDisposal of your old appliance Cleaning for the first time Before using for the first timeBefore using for the first time Induction Induction principleNoises Unsuitable pans PansSuitable pans include Tips on saving energySensor switches UseTo switch the hob on Switching onTo switch a cooking zone on Settings Cooking process SettingsAuto heat-up Heat-up timeTo switch off the Booster function To switch on the Booster functionBooster function To switch off a cooking zone Switching off and residual heat indicatorsTo switch off the hob To activate the safety lock Safety featuresSafety lock To deactivate the safety lockPower setting Maximum Safety switch-offSafety switch-off with an over-long cooking time Safety switch-off if the sensors are coveredOverheating protection Cleaning and care Ceramic surface To set the programme Programme Status SettingProgramming To set the statusWhat to do if Hob or cooking zones cannot be switched on Problem solving guideAppears in the display for a cooking zone One of the following has occurred Optional accessories Safety instructions for installation Safety distance above the appliance Safety distances to the sides and back of the hob Safety distances underneath the hob Flush-fitted hobs Hob with frame or bevelled edges Building-in dimensions 422220 Installing the hob InstallationPreparing the worktop General installation tips Tiled worktopElectrical connection Important U.KElectrical connection Wiring diagram After sales service, data plate Page Alteration rights reserved