Miele KM 5950, KM 5940 Installation, Preparing the worktop, Installing the hob

Page 41

Installation

Preparing the worktop

￿Make the worktop cut-out according to the dimensions given in the building-in diagram. Remember to maintain the minimum safety distances (see "Safety instructions for installation").

￿Seal the cut surfaces on wood/laminated worktops with a suitable heat-resistant sealant to avoid swelling caused by moisture.

Make sure that the sealant does not come into contact with the top of the worktop.

These hobs have a seal underneath them to keep the hob securely in position. Clamps are not required. Any gap between the frame and worktop will reduce with time.

Installing the hob

￿Feed the hob connection cable down through the cut-out.

￿Place the hob centrally in the cut-out. When doing this make sure that the seal under the hob sits flush with the worktop on all sides. This is important to ensure an effective seal all round. Do not use sealant (e.g. silicone).

If the corners of the frame are not flush with the worktop surface, the corner radius (￿ R4) can be carefully scribed to fit.

￿Connect the hob to the mains.

￿Check that the hob works.

41

Image 41
Contents En GB Contents Installation General installation tips Guide to the appliance Guide to the appliance Cooking zone display Sensor switches forControl panel Rating in watts for 230 Cooking zonesCooking zone Correct application Safety with children Technical safety Correct use Page Page Disposal of your old appliance Caring for the environmentDisposal of the packing material Before using for the first time Before using for the first timeCleaning for the first time Induction principle InductionNoises Suitable pans include PansUnsuitable pans Tips on saving energyUse Sensor switchesTo switch a cooking zone on Switching onTo switch the hob on Cooking process Settings SettingsHeat-up time Auto heat-upBooster function To switch on the Booster functionTo switch off the Booster function To switch off the hob Switching off and residual heat indicatorsTo switch off a cooking zone Safety lock Safety featuresTo activate the safety lock To deactivate the safety lockSafety switch-off with an over-long cooking time Safety switch-offPower setting Maximum Safety switch-off if the sensors are coveredOverheating protection Cleaning and care Ceramic surface Programming Programme Status SettingTo set the programme To set the statusAppears in the display for a cooking zone Problem solving guideWhat to do if Hob or cooking zones cannot be switched on One of the following has occurred Optional accessories Safety instructions for installation Safety distance above the appliance Safety distances to the sides and back of the hob Safety distances underneath the hob Flush-fitted hobs Hob with frame or bevelled edges 422 Building-in dimensions220 Preparing the worktop InstallationInstalling the hob Tiled worktop General installation tipsImportant U.K Electrical connectionElectrical connection Wiring diagram After sales service, data plate Page Alteration rights reserved