Miele K 1811 Vi Issue Possible fault Solution Compressor kicks, On very frequently, For too long

Page 31

Frequently asked questions

Issue

Possible fault

Solution

The compressor kicks

The ventilation slits are

Clean with a vacuum or

on very frequently and

covered or dusty.

brush.

for too long.

 

 

The door has been

Once the fridge gets

 

 

opened too frequently, or

down to the set

 

a large amount of fresh

temperature the

 

food has been put in at

compressor will turn off.

 

once.

 

 

 

 

 

The door is not closed.

Check that the door has

 

 

been closed properly.

Issue

Possible fault

Solution

The alarm is ringing.

The appliance door has

Close the door.

 

been open for longer than

 

 

5 minutes.

 

Issue

Possible fault

Solution

The alarm is ringing and

The door is not closed.

Once the alarm condition

the "alarm" indicator is

 

has been corrected, the

A large amount of food

flashing.

alarm will turn off and the

was loaded at the same

 

"alarm" indicator will stop

 

time.

 

flashing.

 

 

 

There has been a power

 

 

 

failure.

 

31

Image 31
Contents En US, CA Contents Contents Electrical Safety Important Safety InstructionsUse InstallationDisposal of your old appliance Save These InstructionsGuide to the refrigerator Control panel Before use Before using for the first timeTurning the appliance On/Off Using the settings SettingsTurning the button sound On/Off Custom settingsFunction Display text Turning off for longer periods of time Temperature alarm Temperature and door alarmDoor alarm Temperature range Setting the temperatureSetting the temperature in the refrigerator Temperature displayTemperature unit Fahrenheit/Celsius Humidity Storage temperaturesUsing the SmartFresh drawers SmartFresh drawersFoods that are best stored under dry conditions Tips for storing food SmartFresh drawersFoods that are best stored under moist conditions Coldest area Using the refrigerator efficientlyDifferent storage zones Warmest areaSwitching off SuperCool Switching on SuperCoolSuperCool Refrigerator and SmartFresh drawers Automatic defrostReplacing the drawer Adjusting the interior fittingsMoving the shelves Deli drawerSmartFresh drawer Removing the storage shelf from above the deli drawer Adjusting the door shelvesTo remove the shelf above the SmartFresh drawers Remove the cleaner promptly Cleaning and careTo better maintain your appliance avoid the following Cleaning the interior and accessories Before cleaningAluminum frames Humidity filters Ventilation slits After cleaningDoor seals Upper lighting Changing the light bulbSide lighting Frequently asked questions For too long Issue Possible fault Solution Compressor kicksAlarm indicator is On very frequentlyCreaking Blubb, blubbClick SssrrrrrMieleCare After sales servicePage Installation instructions Disposal of packing materials Caring for the environmentDisposal of an old appliance Installation site InstallationVentilation Installation nicheBase Furniture/fixturesSingle column Installation optionsStainless steel panels Custom door panelsFrom 5/8 16 mm to 6 5/16 160 mm Installation with partition using the Merging KitInstallation with partition without using the Merging Kit Side panelsFront panel gap kit optional accessory Adjusting the door opening angle optional accessory18X1 DimensionsDoor dimensions open min Door dimensions open min CNiche width a Niche dimensions18X1 30 762 mm 19X1 36 915 mm 18X1 15 381 mm 19X1 18 458 mm Power supply Door front dimensionsBefore you begin Installing the applianceTools needed for installation Optional accessoriesBefore installation Aligning the housing unit Check the installation nicheRemoteVision module installation Preparing the installation niche Anti-tip brackets Mounting AccessoriesInstalling the appliance Securing an alternative anti-tip device Sliding the appliance into the installation space Aligning the appliance Attaching the appliance to the installation niche Installing the appliance Preparing the custom door Installing the appliance Attaching and aligning the custom door front Attaching the fixing brackets Attaching the covers Attaching the toe-kick cover Mounting the air separator Electrical connection RemoteVision optional accessory Accessing the RemoteVision control panel MasterCool control panel options for RemoteVision Status indicators Description of functionSelectable Description of function Options Page Page Alteration rights reserved Nr 169 670