Miele K 1901 Vi Before use, Before using for the first time, Turning the appliance On/Off

Page 9

Before use

Before using for the first time

￿Clean the inside of the appliance and the accessories with a mild solution of warm water and liquid dish soap. Dry with a soft cloth.

If the appliance was transported or laid horizontally for any reason, allow it to stand vertical for at least 8 hours before turning it on. Failure to do so will affect the functioning of the appliance.

Turning the appliance On/Off

￿Open the appliance door.

￿Turn the appliance On/Off with the main switch.

The main switch is located on the right-side underneath the control panel.

All zones are switched on or off together.

Once on, the appliance begins cooling. When the door is open, the interior lights come on.

The access button will light in the control panel.

The preset temperatures (factory settings) are reached after a few hours. Do not put any food in the appliance until the preset temperatures are reached.

￿Switching the appliance off with the main switch does not safely isolate it from the power supply.

9

Image 9
Contents En US, CA Contents Contents Electrical Safety Important Safety InstructionsUse InstallationDisposal of your old appliance Save These InstructionsGuide to the refrigerator Control panel Before using for the first time Before useTurning the appliance On/Off Using the settings SettingsCustom settings Turning the button sound On/OffFunction Display text Turning off for longer periods of time Temperature and door alarm Temperature alarmDoor alarm Setting the temperature in the refrigerator Setting the temperatureTemperature display Temperature rangeTemperature unit Fahrenheit/Celsius Using the SmartFresh drawers Storage temperaturesSmartFresh drawers HumidityTips for storing food SmartFresh drawers Foods that are best stored under dry conditionsFoods that are best stored under moist conditions Different storage zones Using the refrigerator efficientlyWarmest area Coldest areaSwitching on SuperCool Switching off SuperCoolSuperCool Refrigerator and SmartFresh drawers Automatic defrostMoving the shelves Adjusting the interior fittingsDeli drawer Replacing the drawerSmartFresh drawer Adjusting the door shelves Removing the storage shelf from above the deli drawerTo remove the shelf above the SmartFresh drawers Cleaning and care Remove the cleaner promptlyTo better maintain your appliance avoid the following Before cleaning Cleaning the interior and accessoriesAluminum frames Humidity filters After cleaning Ventilation slitsDoor seals Upper lighting Changing the light bulbSide lighting Frequently asked questions Alarm indicator is Issue Possible fault Solution Compressor kicksOn very frequently For too longClick Blubb, blubbSssrrrrr CreakingMieleCare After sales servicePage Installation instructions Caring for the environment Disposal of packing materialsDisposal of an old appliance Installation site InstallationBase Installation nicheFurniture/fixtures VentilationStainless steel panels Installation optionsCustom door panels Single columnInstallation with partition without using the Merging Kit Installation with partition using the Merging KitSide panels From 5/8 16 mm to 6 5/16 160 mmFront panel gap kit optional accessory Adjusting the door opening angle optional accessoryDoor dimensions open min DimensionsDoor dimensions open min C 18X1Niche dimensions Niche width a18X1 30 762 mm 19X1 36 915 mm 18X1 15 381 mm 19X1 18 458 mm Power supply Door front dimensionsTools needed for installation Installing the applianceOptional accessories Before you beginBefore installation Aligning the housing unit Check the installation nicheRemoteVision module installation Preparing the installation niche Anti-tip brackets Mounting AccessoriesInstalling the appliance Securing an alternative anti-tip device Sliding the appliance into the installation space Aligning the appliance Attaching the appliance to the installation niche Installing the appliance Preparing the custom door Installing the appliance Attaching and aligning the custom door front Attaching the fixing brackets Attaching the covers Attaching the toe-kick cover Mounting the air separator Electrical connection RemoteVision optional accessory Accessing the RemoteVision control panel Status indicators Description of function MasterCool control panel options for RemoteVisionSelectable Description of function Options Page Page Alteration rights reserved Nr 169 670