Scotsman Ice MDT5N25, MDT5N40 service manual Operation Water

Page 14

MDT5N25 & MDT5N40

OPERATION: Water

Water enters the machine through the 3/8" male flare at the rear of the cabinet, goes to a strainer and then to the water reservoir which it enters through the float valve. The water then goes out the bottom of the reservoir tank to the bottom of the evaporator.

Reservoir overflow, evaporator condensation and water in the sink are all routed to the drain. Water cooled models have a separate water circuit for the cooling water: it enters the fitting at the rear, goes to the water regulating valve, then to the water cooled condenser and down the drain.

There is also an additional water circuit to an electric valve. When the Touch Free system senses a container for water, it closes a circuit to the electric water valve, and water is dispensed.

Note: The correct water level is determined when the machine is operating. Check the water level and compare it to the line molded into the side of the reservoir. The water level should be between “ above and " below the line.

If needed, adjust the water level by bending the

float arm.

WATER RESERVOIR

WATER

LEVEL

WATER INLET

WATER DRAIN

WATER LINE FOR

WATER STATION

May 2001

Page 14

Page 13 Page 15
Image 14
Page 13 Page 15
Contents Table of Contents IntroductionMDT5N25 & MDT5N40 Minimum Maximum For the Installer Environmental LimitationsInstallation Limitations Service Limitations Water LimitationsCounter Top or Machine Stand Installation For the InstallerMachine Stand Installation Unpack and install the ice and water spoutsFor the Installer Wall Mount Kit For the Plumber Conform to ALL Applicable CodesFor the Electrician For the Installer Final Check List Start Up Initial Start UPPre Start Inspection Component Description ICE Sweep Bearing Breaker Motor Evaporator Auger Water Seal Circuit Board On/Off Switch ManualComponent Description Control Box Potential RelayStart up consists Splash panel cleaningElectrical Sequence Shut Down consistsOperation Water Refrigeration Schematic Operation RefrigerationOperation Ice Vending ContainerDispense Area Sanitation To Sanitize Cleaning and SanitizingScotsman Ice Machine Cleaner contains acids Check and tighten all bolts and screws Maintenance and Cleaning Moving Parts HazardService Diagnosis Symptom Possible Cause Probable CorrectionMDT5N25 & MDT5N40 Off Timer Service Diagnosis Circuit BoardPower Bin EmptyRemoval and Replacement BIN Controls Ice Level SensorsRemoval and Replacement Bearing And Breaker To Remove the Breaker Bearing AssemblyTo Remove the Auger To Replace the Water Seal Removal and Replacement Water SealTo Remove the Water Seal To Reassemble the Evaporator and Auger For Access to the Evaporator to Gearmotor boltsTo Replace the Evaporator To Inspect the gearmotor To Remove and Repair the Gearmotor AssemblyElectrical Shock Hazard Refrigeration Service R-404A HP62 Do not USE Mineral OIL in this Refrigeration SystemOnly a HFC type dryer should be used Refrigeration ServiceGeneral Information Liquid Charging Circuit Board ServicePrinted Circuit Board Handling Precautions Instructions for R-404A

MDT5N40, MDT5N25 specifications

The Scotsman Ice MDT5N25 and MDT5N40 models are part of a sophisticated line of ice machines designed for commercial use. These models stand out for their efficiency, reliability, and advanced technology, making them ideal for restaurants, bars, and other food service establishments that require a constant supply of ice.

One of the main features of the Scotsman MDT5N25 and MDT5N40 models is their ability to produce high volumes of ice quickly while maintaining energy efficiency. These machines are designed to provide a steady supply of ice, ensuring that businesses can meet the demands of their customers without interruption. The MDT5N25 can produce approximately 260 pounds of ice per day, while the MDT5N40 takes it a step further by producing around 450 pounds daily. These capacities make both models suitable for various applications, from small cafes to larger dining venues.

Both models are equipped with Scotsman’s proprietary EcoX technology, which enhances energy efficiency and reduces water consumption. This technology employs advanced engineering designs that minimize waste and optimize production cycles. This focus on sustainability not only helps reduce operational costs but also appeals to environmentally conscious businesses.

The MDT5N25 and MDT5N40 also feature a self-cleaning mechanism that simplifies maintenance and ensures consistent ice quality. The automatic cleaning cycle helps prevent limescale and bacteria buildup, providing peace of mind for operators who prioritize hygiene and food safety.

In terms of design, both models boast a compact footprint, making them suitable for establishments with limited space. They come with a built-in storage bin that efficiently holds large quantities of ice, streamlining operations and making it easy for staff to access ice when needed. The sleek stainless steel finish of the machines not only enhances their durability but also ensures they can blend seamlessly into any commercial kitchen environment.

The user-friendly control panel on both the MDT5N25 and MDT5N40 allows for easy adjustments and monitoring of the machine’s performance. Operators can easily keep track of production levels and patterns, ensuring they can manage their ice supply effectively.

In conclusion, the Scotsman Ice MDT5N25 and MDT5N40 models represent a robust solution for commercial ice production, combining efficiency, advanced technology, and ease of use. With their impressive output capacities, energy-efficient designs, self-cleaning features, and durable construction, these machines are perfect for businesses that rely on consistent ice production to meet their needs.
Top Page Image Contents