MDT5N25 & MDT5N40
MAINTENANCE AND CLEANING
In some areas, the water supply to the ice maker will contain a high concentration of minerals, and that will result in an evaporator and auger becoming coated with these minerals, requiring a more frequent removal than twice per year. If in doubt about the condition of the evaporator and auger, the auger can be removed so the parts can be inspected.
Moving Parts Hazard.
Disconnect electrical power to the icemaker - dispenser before beginning.
Note: Water filters can filter out suspended solids, but not dissolved solids. “Soft” water may not be the complete answer. Check with a water treatment specialist regarding water treatment.
For more information on removal of these parts, see REMOVAL AND REPLACEMENT.
1.To remove the auger, remove the front and top panels.
2.Push bail clamp off of cover and remove cover.
3.Unscrew and remove ice sweep.
4.Remove ice chute from evaporator.
5.Remove 4 allen screws holding breaker to evaporator.
6.Pull up to remove auger.
After the auger has been removed, allow the auger to dry: if the auger is not bright and shiny, it must be cleaned.
Clean the auger and evaporator as required. DO NOT HONE THE EVAPORATOR.
7.Replace the water seal.
8.Reverse to reassemble.
ALLEN
HEAD
SCREWS
BREAKER
AND AUGER
ASSEMBLY
May 2001
Page 20