1 
2 
3
4 
5 
6
7 
8 
9
0
Removing and Cleaning the Filters
To remove, slide them to the rear using the tabs. Pull down and out.
To clean the vent filters, soak them and then swish around in hot water and detergent. Don’t use ammonia or ammonia products because they will darken the metal. Light brushing can be used to remove embedded dirt.
Rinse, shake and let dry before replacing.
To replace, slide the filters into the frame slots on the back of each opening. Press up and to the front to lock into place.
Charcoal Filter
The charcoal filter cannot be cleaned. It must be replaced. Order Part No. WB02X10956 from your GE supplier.
If the model is not vented to the outside, the air will be recirculated through a disposable charcoal filter that helps remove smoke and odors.
The charcoal filter should be replaced when it is noticeably dirty or discolored (usually after 6 to 12 months, depending on usage). See “Optional Kits,” page 8, for more information.
1 
2 
3
4 
5 
6
7 
8 
9
0
Remove 2 grille screws to remove
the grille.
To Remove the Charcoal Filter
To remove the charcoal filter, first disconnect power at the main fuse or circuit breaker,
or pull the plug. Remove the top grille by removing the two screws that hold it in place.
You may need to open the cabinet doors to remove the screws.
Lift the filter at the bottom until it comes free of the tabs. Slide the filter down and out.
29 |