GE JVM2070_H manual Side Stirrer Motor, Removal

Page 10

Side Stirrer Motor

Side Stirrer Motor

The side stirrer motor is located on the left side of the microwave oven.

Resistance through the side stirrer motor from the power cord (L) to CN04 pin 5 is approximately

6.7ohms. Isolated, the side stirrer motor is approximately 7.0 ohms. The door (primary interlock) must be closed to complete circuit. Check motor circuit for 21 VAC when operating.

Removal

Remove the microwave (see Microwave Removal and Component Access).

Disconnect the wire connector to the side stirrer motor. Remove the screw and turn the motor 1/8 turn CCW.

Note: When installing stirrer motor, be sure the locating pin is inserted in the motor mounting tab and the side stirrer is resting on the support in the cover prior to installing the screw.

Side Stirrer

Removal

Open the oven door. Pull the plastic rivet out of the stirrer cover. Rotate the stirrer cover CCW until it stops and remove the stirrer cover.

Rivet

Remove the stirrer.

Stirrer

Screw

Disconnect

Note: When assembling, assure that the stirrer rides on the support in the cover.

– 10 –

Image 10

Contents TECHNICAL SERVICE GUIDE PUB #2/04 Over the Range Microwave Oven MODEL SERIES JVM2070HRECONNECT ALL GROUNDING DEVICES IMPORTANT SAFETY NOTICETechnical Service Guide Copyright GE Consumer & IndustrialA. DO NOT OPERATE OR ALLOW THE OVEN TO BE OPERATED WITH THE DOOR OPEN Table of Contents Nomenclature InstallationFeature Pack Model NumberHELP Control FeaturesTouchscreen Display HOMEComponent Locator Views Top View3 - High Voltage Transformer Right Side View1 - Magnetron 2 - Magnetron Thermal Cutout TCO 4 - Magnetron Cooling Fan Motor and Blade 5 - High Voltage CapacitorExhaust Fan Microwave Removal and Component AccessComponents RemovalSide Stirrer Motor Side StirrerTop Stirrer Motor Top StirrerCooling Fan and Motor Magnetron Thermal Cutout TCO Cavity Thermal Cutout TCOFuses Gas Sensor MagnetronTransformer Hidden Vent Motor Interior LightMonitor Switch Door Interlock SwitchesDoor Sensing and Primary Interlock Switches Control PanelPower Relay Interlocks Door Latch SwitchesDoor Sensing Switch Primary Interlock Switch TestBottom and Hood Thermal Cutout TCO Removal and ReplacementHigh Voltage Capacitor Turntable MotorSurface Lamp Assemblies Surface LampsControl Performance Test TroubleshootingSensor Test Quick Test Demonstration Mode Diagnostics TestError Message Displayed InformationPerformance Test Microwave Leakage TestHigh Voltage Capacitor CN04 - Cooktop Lamp Relay Connector CN01 - Ribbon connectorCN03 - Vent Blower Connector CN06 - Door Sensing ConnectorLouver Motor Does Not Work Vent Motor Does Not Work Strip CircuitsFan Motor Does Not Work Dead Unit - Bottom TCO Does Not Work Top Stirrer, Side Stirrer, or Drive Motor Does Not WorkDead Unit - Cavity or Magnetron TCO Does Not Work FAN MOTORInterior Light Does Not Work Surface Lamps Do Not Work 3 - Blue Magnetron Does Not Work2 - White BlackWiring Diagram WARNING Power must be disconnected before servicing this applianceSchematic Code No. DE99-00125FIllustrated Parts Catalog DESCRIPTION VIEW NUMBERCATALOG NUMBER QUANTITYPLATE MOUNTING ASM GE will replace WarrantyFor the period of Full one-year