GE JVM2070_H manual Cooling Fan and Motor, Removal

Page 12

Cooling Fan and Motor

Resistance through the cooling fan motor from the power cord (L) to CN04 pin 7 is approximately

24.7ohms. The door (primary interlock) must be closed to complete circuit.

The cooling fan motor, in series with the drive motors, provides voltage reduction to 21 VAC.

Removal

Remove the microwave (see Microwave Removal and Component Access). Remove the screw at the top of the control panel.

Slide the control panel up and remove it. Disconnect 8 electrical connectors and the ground wire from the control panel.

Move the TCO out of the way. Disconnect the power transformer.

Remove 3 screws from the fan motor mounting plate. Slide the mounting plate forward to allow access to the fan blade. Slide the fan blade off of the fan motor shaft.

Remove 2 screws from the fan motor.

Remove the fan motor from the fan mounting plate and remove the 2 wires.

– 12 –

Image 12

Contents PUB # 2/04TECHNICAL SERVICE GUIDE Over the Range Microwave Oven MODEL SERIES JVM2070HIMPORTANT SAFETY NOTICE Technical Service Guide CopyrightRECONNECT ALL GROUNDING DEVICES GE Consumer & IndustrialA. DO NOT OPERATE OR ALLOW THE OVEN TO BE OPERATED WITH THE DOOR OPEN Table of Contents Installation Feature PackNomenclature Model NumberControl Features Touchscreen DisplayHELP HOMEComponent Locator Views Top ViewRight Side View 1 - Magnetron 2 - Magnetron Thermal Cutout TCO3 - High Voltage Transformer 4 - Magnetron Cooling Fan Motor and Blade 5 - High Voltage CapacitorMicrowave Removal and Component Access ComponentsExhaust Fan RemovalSide Stirrer Motor Side StirrerTop Stirrer Motor Top StirrerCooling Fan and Motor Cavity Thermal Cutout TCO Magnetron Thermal Cutout TCOFuses Magnetron Gas SensorTransformer Hidden Vent Motor Interior LightDoor Interlock Switches Door Sensing and Primary Interlock SwitchesMonitor Switch Control PanelInterlocks Door Latch Switches Door Sensing SwitchPower Relay Primary Interlock Switch TestRemoval and Replacement High Voltage CapacitorBottom and Hood Thermal Cutout TCO Turntable MotorSurface Lamp Assemblies Surface LampsTroubleshooting Control Performance TestSensor Test Quick Test Diagnostics Test Error MessageDemonstration Mode Displayed InformationMicrowave Leakage Test Performance TestHigh Voltage Capacitor CN01 - Ribbon connector CN03 - Vent Blower ConnectorCN04 - Cooktop Lamp Relay Connector CN06 - Door Sensing ConnectorStrip Circuits Louver Motor Does Not Work Vent Motor Does Not WorkFan Motor Does Not Work Top Stirrer, Side Stirrer, or Drive Motor Does Not Work Dead Unit - Cavity or Magnetron TCO Does Not WorkDead Unit - Bottom TCO Does Not Work FAN MOTORInterior Light Does Not Work Surface Lamps Do Not Work Magnetron Does Not Work 2 - White3 - Blue BlackWiring Diagram WARNING Power must be disconnected before servicing this applianceSchematic Code No. DE99-00125FIllustrated Parts Catalog VIEW NUMBER CATALOG NUMBERDESCRIPTION QUANTITYPLATE MOUNTING ASM Warranty For the period ofGE will replace Full one-year