LIGHT BULB ~PLACEMENT
Cooktop Ligh~ight Light
To replace combination cooktop/night light, first disconnect power at main fuse or
circuit breakerREMOVE-SCREWpanel or pull plug.
With smoke and spatter shield (on model so equipped) in the OUT position, remove screw on right side of light compartment cover and lower cover until it stops.
Be sure bulbs | II I | I Ilull |
to be replaced |
|
|
are cool before |
|
|
removing. Break |
|
|
the adhesive |
|
|
seal by gently |
| \ |
unscrewing the |
| |
|
|
bulbs. Replace with
Oven Light
To replace your oven light, first disconnect power at main fuse or circuit breaker panel or pull plug. Remove the top grill by taking out the 2 screws that hold
it in place.
Next, remove the single screw located above door near center of oven that secures light housing. Replace
a
Clean off the grease and dust on hood surfaces often. Use a solution of warm water and detergent. About 1 tablespoon of ammonia maybe added to the water. Take care not to touch the filters and enamel surfaces with this solution; ammonia will darken metal. Wash the smoke
and spatter shield (on model so equipped) with a solution of warm water and detergent.
THE EXHAUST FEATU~
The exhaust hood feature on your microwave oven is equipped with
2 metal filters which collect grease. When the fan is operated, air is drawn up through the filters and is then discharged through the provided venting to the outside.
I METAL COOKTOP METAL
FILTER LIGHT FILTER
SMOKE & SPATTER SHIELD (On model so equipped)
34