Reusable Grease Filters
The grease filters should be cleaned at least once a month. Never operate the microwave without the filters in place. In situations where flaming might occur on surfaces below hood, filters will stop the entry of flames into the unit.
To Remove Grease Filter
To Clean and Replace Grease Filter
~ -
—
To remove grease filter, grasp the “finger ring” on the filter and slide to the rear. Then pull filter downwardandtothe front. The filter will drop out.
To clean grease filter, soak it and then agitate filter in solution of hot water and detergent. Don’t use ammonia or ammonia products because they will darken the metal. Light brushing can be used to remove embedded dirt.
Rinse, shake and remove moisture before replacing.
To replace grease filter, slide the filter in the frame slot on the back of the opening.
Pull filter upward and to the front to lock into place.
Charcoal Filter Kit (for some models)
There is a Recirculating Charcoal Filter Kit available for models that are not vented to the outside. (The filter kit cannot be used on the model JVMI 72 K.)
Filter Kit model
GROUND~G ~STRUCTIONS
This appliance must be grounded. In the event of an electrical short circuit, grounding reduces the risk of electric shock by providing an escape wire for the electric current. This appliance is equipped with a power cord having a grounding wire with a grounding plug. The plug must be plugged into an outlet that is properly installed and grounded. (Fig. 1)
use of the grounding plug can result in a risk of electric shock.
Ensure proper ground
Fig. 1 exists before use
Consult a qualified electrician or service technician if the grounding instructions are not completely understood, or if doubt exists as to whether the appliance is properly grounded.
Where a standard
aproperly grounded
Do not under any circumstance cut or remove the third (ground) prong from the power cord.
Do not use an adapter plug with this appliance.
Do not use an extension cord with this appliance.
35