GE 165D4700P382 Flashing display lights, Using the dishwasher, Check the Water Temperature

Safety Instructions

Operating Instructions

Tips

About the dishwasher control panel.

5Start

Close the dishwasher door and select the cycle and desired enhancements. Touch the START/RESET pad to begin the cycle. Water fill begins, and approximately 60 seconds later the wash action begins.

NOTE: The dishwasher remembers your last cycle so you don’t have to reprogram each time. When the dishwasher door is fully closed, the control panel lights will display the last settings you selected.

If you don’t want to change any of the settings, simply touch the START/RESET pad to begin the cycle.

If the door is closed, the indicator lights will turn off if the START/RESET pad is not selected within two minutes. To activate the display, open and close the door or press any pad.

Also, if a power failure occurs, NORMAL and HEATED DRY will automatically be programmed. Make any new selections and touch the START/RESET pad to begin the cycle.

6Clean

The CLEAN light will illuminate and a double beep will sound when a wash cycle is complete. On some models,

the CLEAN light will turn off when the door is opened. On other models, the CLEAN light will remain on until the door is opened and then relatched or until any keypad is pressed while the door is latched shut.

Flashing display lights.

Status Indicator Lights	What It Means
START/RESET	Cycle has been interrupted by pressing the START/RESET pad. Light will stop
	flashing after the dishwasher automatically drains out the water.

Using the dishwasher.

Check the Water Temperature

The entering water should be at least 120°F (49°C) and	faucet nearest the dishwasher, place the thermometer in
not more than 150°F (66°C) for effective cleaning and to	a glass and let the water run continuously into the glass
prevent dish damage. Check the water temperature with	until the temperature stops rising.
a candy or meat thermometer. Turn on the hot water

Use Jet-Dry ® or Cascade Crystal Clear® Rinse Agent

Jet-Dry®or Cascade Crystal Clear® rinse agents remove spots and prevent new film buildup on your dishes, glasses, flatware, cookware and plastic.

Troubleshooting

Filling the Dispenser

The rinse agent dispenser holds 3.5 oz. (99 g.) of rinse agent. Under normal conditions, this will last approximately one month. Try to keep it full, but do not overfill.

1Make sure the dishwasher door is fully open.

2Turn the dispenser cap to the left and lift it out.

3Add rinse agent until the indicator window looks full.

4Clean up any spilled rinse agent with a damp cloth.

5Replace the dispenser cap.

Indicator
window	Dispenser cap

Support

Rinse Aid Setting

The amount of rinse agent released into the final wash can be adjusted. The factory setting is at the midpoint. If there are rings of calcium (hard water) spots on dishes, try a higher setting. If you see foam in the dishwasher, move the indicator to a lower setting.

To adjust the setting

Remove the dispenser cap; then turn the adjuster counterclockwise to increase the amount of rinse agent, clockwise to reduce the amount of rinse agent.

Rinse agent adjuster

Consumer

Dish Preparation Prior to Loading

	■ No prerinsing of normal food soil is required.	■ Remove leafy vegetables, meat trimmings and
	■ Scrape off hard soils, including bones, toothpicks, skins	excessive amounts of grease or oil.
	and seeds.	■ Remove acidic food soils that can discolor stainless
6	■ Remove large quantities of any remaining food.	steel.