Manual Detergent Dispenser, Number, Grains

ge.com

Manual Detergent Dispenser

Safety

Your dishwasher comes equipped with a manual dispenser and, on some models, an automatic liquid dishwasher detergent dispenser (SmartDispenseTM). You can use either of these dispensers, but don’t use both at the same time.

SmartDispenseTM

For heavily soiled loads, use a bit more detergent. For water temperatures above 140°F (60°C), use a bit less detergent.

	Medium	Medium	Extremely
Soft	Soft	Hard	Hard

Instructions

Manual Detergent

Dispenser

For heavily soiled loads, use the Pots and Pans or Heavy Wash cycle.

Operating

The cover of the main wash section will open during the wash cycle. If you are using SmartDispenseTM, leave the cover of the main wash section dispenser open before starting the cycle.

You may use powder, liquid, gel or tablets in the manual dispenser. It is important to keep powdered detergents and tablets fresh and dry so they don’t lose effectiveness. Therefore, do not put detergent into the manual dispenser until you are ready to wash dishes.

Filling Manual Detergent Dispenser

The amount of detergent to use depends on whether your water is hard or soft. With hard water, you need extra detergent. With soft water, you need less detergent.

Protect your dishes and dishwasher by contacting your water department and asking how hard your water is. Twelve or more grains is extremely hard water. A water softener is recommended. Without it, lime can build up in the water valve, which could stick while open and cause flooding. Too much detergent with soft water can cause a permanent cloudiness of glassware, called etching.

Use the information in the table below as a guide to determine the amount of automatic dishwasher detergent to place in the dispenser. You may use powder, liquid, gel or tablets in this dispenser.

When using automatic dishwashing detergent tablets, simply place one tablet in the main wash section and close the cover.

Number
of Grains	Detergent Cups to Fill

Less than 4	Fill cup to soft line (1/3 full)

4 to 8	Fill cup to medium soft line (2/3 full)

8 to 12	Fill cup to medium hard line
	(completely full)

Greater	Fill both main wash cup
than 12	and pre wash cup

DO NOT USE HAND DISH DETERGENT

NOTE: Using a detergent that is not specifically designed for dishwashers will cause the dishwasher to fill with suds. During operation, these suds will spill out of the dishwasher vents, covering the kitchen floor and making the floor wet.

Because so many detergent containers look alike, store the dishwasher detergent in a separate space from all other cleaners. Show anyone who may use the dishwasher the correct detergent and where it is stored.

While there will be no lasting damage to the dishwasher, your dishes will not get clean using a dishwashing detergent that is not formulated to work with dishwashers.

Instructions

Troubleshooting Tips

Consumer Support

165D4700P382 specifications

The GE 165D4700P382 is a highly regarded component within the realm of industrial and commercial applications, known for its robustness and reliability. This device serves as a vital part of various electrical systems, providing efficient performance and superior operation in challenging environments.

One of the main features of the GE 165D4700P382 is its advanced protection capabilities. It is designed to safeguard equipment from overloads, short circuits, and voltage spikes, thereby prolonging the life of connected machinery and reducing the likelihood of failures. This protective functionality is essential in environments where electrical disturbances can lead to significant downtime and costly repairs.

The GE 165D4700P382 incorporates cutting-edge technology that enhances its efficiency and versatility. This component is equipped with state-of-the-art microprocessor-based controls that allow for precise monitoring and management of the electrical system. These controls enable functionalities such as adjustable trip settings, remote monitoring, and integration into automated systems, making it an adaptable choice for contemporary industrial settings.

Another key characteristic of the GE 165D4700P382 is its robust construction. Built to withstand extreme temperatures and harsh environmental conditions, this component is rated for high performance even in the most demanding applications. Its housing is designed to resist dust, moisture, and other contaminants, ensuring reliable operation without the need for frequent maintenance.

The device's compact design facilitates easy integration into existing electrical systems, making installation straightforward and efficient. Furthermore, the GE 165D4700P382 offers various mounting options, allowing for flexibility in deployment depending on the specific requirements of the application.

In summary, the GE 165D4700P382 stands out due to its advanced protection features, high-performance microprocessor technology, robust construction, and user-friendly design. These characteristics make it an indispensable asset in industrial and commercial settings, ensuring optimal performance and reliability in electrical systems. As industries continue to evolve with increasing demands for efficiency and safety, the GE 165D4700P382 remains a trusted choice for professionals seeking quality and innovation in their electrical components.

ge.com