Samsung RF261BEAESR Accessories and required tools, Removing the refrigerator doors, Flooring

FLOORING

For proper installation, you must place this refrigerator on a level, hard surface that is the same height as the rest of the floor. This surface should be strong enough to support a fully loaded refrigerator, or approximately 331lbs (150kg).

To protect the finish of the flooring, cut a large section of the cardboard carton and place it under the refrigerator where you are working. When moving the refrigerator, you need to pull and push it straight forwards or back. Do not wiggle it from side to side.

Accessories and required tools

The following accessories are included with your refrigerator:

Hex wrench Fastener

Removing the refrigerator doors

For some installations you need to remove the	up
fridge and freezer drawers so you can move the
refrigerator to its final location. Do not remove
the doors/drawer if you don’t need to. If you do
not need to remove the refrigerator doors, go
to Adjusting the Level on page 9. If you need to	01setting
remove the doors. continue below.
Before removing the door/drawer, make sure you
read the following items:

Disconnect power to the refrigerator before WARNING removing the door or drawer.

•• Be careful not to drop, damage or scratch the door/drawer while removing them.

•• Be careful not to get injured while removing the door/drawer.

•• Reattach the door/drawer properly to avoid: -- Moisture from air leakage.

-- Uneven door alignment.

-- Wasting energy due to improper door seal.

Disassemble the refrigerator doors

Be careful not to drop and scratch the

WARNING doors while removing the doors.

With the door opened

111 Remove 3 screws holding down the TOP TABLE ( 1 ) and turn it with wires connected.

1

Required Tools (Not provided)

You need the following tools to complete the installation of your refrigerator:

Philips	Flat-blade screw	Socket wrench
screwdriver(+)	driver(-)	(10mm)
Pliers	Allen wrench
	(3/16”) (5mm)

222 Disconnect two connector ( 2 ) on the left side door. To remove the water coupler from the hinge, twist and pull it from the hinge.

2

setting up _07

DA68-02601B(EN+ES+FR)-0.0.indb 7

2012.3.29 9:28:31AM