Amana ARR6202, ART6112, ART6002, ARR6102 owner manual Oven Control, Timer

Page 14

OFF

OVEN BROIL

WM

PREHEATED550" /

_

350

500

/ 450 / 400

 

Oven

Control

 

 

 

 

 

 

 

TIMER

Pad

Selects timer

feature. Timer can be set up to 11 hour

59 seconds.

Timer does not control

 

 

oven operation.

 

 

 

 

 

 

TIMER pad has light that flashes when timer is being set and glows when timer is counting

 

 

down.

 

 

 

 

 

 

CLOCK

Pad

Press to set clock and turn clock display on and off.

 

 

 

HRS Pads

Increases

or decrease

time by hours.

 

 

 

MIN Pads

Increase

or decrease

time by minutes.

 

 

 

OVEN

Light

Glows when

oven is on. Light flashes after self-clean

cycle turns

off as a reminder

to turn

 

 

temperature

knob to OFF.

 

 

 

LOCKED Light

Glows when

oven door is locked and oven is set for self-cleaning.

After self-clean

cycle,

light flashes. Unlatch oven door and turn temperature knob to OFF.

PREHEATED

Light

Temperature

Knob

Time Display

Other Features

12-hour automatic cancel

Service codes and tones

Glows when oven reaches selected temperature.

Controls oven temperature, self-clean, and broil. Push-to-turn knob prevents accidentally turning oven on.

Shows the time-of-day and timer minutes.

Timer light allows the user to identify timer mode quickly and easily.

As a safety feature, oven control automatically shuts off oven after 12 hours of operation. This feature can be turned on or off.

To allow the oven to operate for more than 12 hours, confirm temperature knob is in OFF position. Then, press and hold the MINS + and - pads for approximately

4 seconds. Display will change from time-of-day, show "OFF", and then return to time-of- day.

To set oven to shut off after 12 hours, confirm temperature knob is in the OFF position. Then, press and hold the MINS + and - pads for approximately 4 seconds. Display will change from time-of-day, show "ON", and then return to time-of-day.

Electronic oven control is equipped with a self diagnostic system. Self diagnostic system alerts you if there is an error or problem in the control. If the range control sounds a series of short, rapid beeps for over 16 seconds and display shows a F-code, record the F-code shown. Some F-codes can be cleared by disconnecting power to the range. If the code

continues to reoccur call an authorized servicer. Disconnect electrical supply to range and contact an authorized servicer.

F2--High Oven Temperature

F3--Temperature Sensor Malfunction

F4--Temperature Sensor Malfunction

14

Image 14
Contents Please Read Manual Before Operating Range Installer CustomerContents IM Portant Safety Information Precautions Case of FireRange Location InstallationPacking Material Cabinet OpeningIrregular Cabinet and Countertop Heights Power Cord RequirementsPower Supply Location Line Voltage RequirementsAI B Installing 4-Wire Power Cord Wires from power cordRemoval and Replacement of Range Converting 3-Wire to 4-Wire Power CordAnti-tip Bracket Installation Level RangeRange Features OperationRange Control PanelSurface Element Settings Cooking with Surface ElementsUtensils Utensil Material CharacteristicType Temperature Timer Oven ControlResetting and Canceling Timer Setting Electronic ClockSetting Electronic Timer Prepare to BakeAdjusting Factory Set Baking Temperature BakingPrepare for Self-clean BroilingSelf-cleaning After Self-cleaning CycleBaking Guide Oven TemperatureCooking Guide Poultry Roasting GuideBroiling Guide Food Oven Temperature Cooking TimeBeef and Pork Roasting Guide Thickness Rack positionRemoving Storage Drawer Some Models Care and CleaningRemoving Oven Door Replacing Oven Light Removing Panel Some ModelsCleaning Part Materials to Use General DirectionsTo Remove Cleaning Smoothtop RangetopCause Before Calling For Service Problem CheckWarranty Page Page Quick Reference Instructions