Amana ART6002, ART6112, ARR6202, ARR6102 Care and Cleaning, Removing Oven Door Replacing Oven Light

Page 21

Care and Cleaning

Removing Oven Door

Replacing Oven Light

[CAUTION1

To avoid personal injury or property damage, handle oven door with care.

Door is heavy and can be damaged if dropped.

Avoid placing hands in hinge area when door is removed. Hinge can snap closed and pinch hands.

Do not scratch or chip glass, or twist door. Glass may break suddenly.

Replace door glass if damaged.

Do not lift door by handle.

. Open door fully.

2.Remove screws.

Oven doors are attached with a screw on each side of lower oven door.

. Close door to first stop, grasp door firmly on each side, and lift upward until door is off hinges.

Do not lift door by handle. Glass can break.

Only push hinges closed once oven door is removed if necessary. Use both hands when closing hinge. Hinge snaps closed.

WARNING

To avoid risk of burns or electrical shock, disconnect electrical supply to oven before changing light bulb.

Before replacing light bulb make sure bulb is cool.

Do not operate oven without bulb and cover in place.

CAUTION

Wear gloves to protect hands from accidental bulb breakage.

1.Disconnect electrical supply.

2.Remove oven door if desired.

3.Unscrew light bulb cover located in rear of oven cavity. Then turn light bulb counterclockwise to remove.

4.Replace light bulb with 120-volt, 40-watt appliance bulb.

Do not overtighten bulb or it may be difficult to remove later.

5.Replace light bulb cover and oven door before use.

6.Reconnect power supply.

7

Removing Oven Door

Removing Storage Drawer (Some Models)

1.Slide drawer out until it stops.

2.Grasp drawer sides near back of drawer.

3.Lift up and out. Reverse to reinstall.

Replacing Oven Light Bulb

Removing Panel (Some Models)

1.Remove 2 screws at bottom of panel.

2.Push panel up so tabs on top of panel clear range frame.

3.Lift panel away from range.

• Reverse to reinstall.

./

Removing Storage Drawer

21

Removing Panel

Image 21
Contents Customer Please Read Manual Before Operating Range InstallerContents IM Portant Safety Information Case of Fire PrecautionsPacking Material InstallationRange Location Cabinet OpeningPower Supply Location Power Cord RequirementsIrregular Cabinet and Countertop Heights Line Voltage RequirementsAI B Wires from power cord Installing 4-Wire Power CordAnti-tip Bracket Installation Converting 3-Wire to 4-Wire Power CordRemoval and Replacement of Range Level RangeOperation Range FeaturesPanel Range ControlCooking with Surface Elements Surface Element SettingsUtensil Material Characteristic Type TemperatureUtensils Oven Control TimerSetting Electronic Timer Setting Electronic ClockResetting and Canceling Timer Prepare to BakeBaking Adjusting Factory Set Baking TemperatureBroiling Prepare for Self-cleanAfter Self-cleaning Cycle Self-cleaningCooking Guide Oven TemperatureBaking Guide Poultry Roasting GuideBeef and Pork Roasting Guide Food Oven Temperature Cooking TimeBroiling Guide Thickness Rack positionRemoving Oven Door Replacing Oven Light Care and CleaningRemoving Storage Drawer Some Models Removing Panel Some ModelsPart Materials to Use General Directions CleaningCleaning Smoothtop Rangetop CauseTo Remove Problem Check Before Calling For ServiceWarranty Page Page Quick Reference Instructions