Amana Bottom Mount Refrigerator service manual Disassembly Procedures

Ice Maker

Module Ohmmeter Checks

No Power to Ice Maker and

Ejector Blades in End of Cycle Position

Test Points		Component	Module Position	Ohms
L - H		Mold and heater	Attached to support	264
L - M		Motor	Separated from heater	16,100
	Module Voltage Checks with Meter or Test Light
		Power to Ice Maker
Test Points		Component	Line Voltage	0 Volts
L - N		Module	Power on	Power off
T - H		Bimetal	Open	Closed
L - H		Heater	On	Off
L - M		Motor	On	Off
N - V		Water valve	On	Off

Module, Motor, and Support Assembly

1.Loosen both screws in module access ports.

2.Disconnect shut-off arm.

3.Pull mold from support assembly.

Remove module only by removing 3 screws and pulling module out of housing.

Shut-Off Arm

1.Pull shut-off arm out from white bushing.

2.Replace by pushing completely in.

3.Follow steps below.

Disassembly Procedures

Cover

1.Pull water adjustment knob forward.

2.Snap off cover.

WARNING

To avoid electrical shock which can cause severe personal injury or death, disconnect power to refrigerator using power switch before servicing. Wires removed during disassembly must be replaced on proper terminals to insure correct earthing and polarization. After servicing, reconnect power using power switch.

Shut off arm

Adjustment screw

Mold attachment screw access ports

Module and Heater Assembly

1.Remove module and support assembly.

2.Install module and support assembly on replacement mold and heater assembly.

Fill Cup

1.Remove module and support assembly.

2.Remove ejector blades and shut-off arm.

3.Pull fill cup from mold.

November 1996 43 RS1200001