Ice Maker Troubleshooting Chart
| 3:00 Ejector Position | |
|
|
|
Contaminated |
| Replace module |
|
|
|
Jammed cubes |
| |
Notice size and density of cubes |
|
|
|
|
|
Refrigerator or ice maker not level |
| Level refrigerator or ice maker |
|
|
|
No power to ice maker |
| Determine discontinuity by tracing power |
|
|
|
Excessive |
| Adjust module screw, lower water pressure, or |
|
| replace water valve |
|
|
|
Cubes falling back into mold during |
| Replace fill cup |
ejection |
| Check fill tube assemby |
|
|
|
| 4:00 Ejector Position | |
|
|
|
Contaminated |
| Replace mold and heater assembly |
|
| Apply alumilastic |
|
|
|
Thermostat out of calibration |
| Replace thermostat |
|
| Apply alumilastic |
|
|
|
Open heater circuit |
| Replace mold and heater assembly |
Motor should oscillate |
| Apply alumilastic |
|
|
|
Little or no alumilastic on thermostat |
| Apply alumilastic to thermostat |
|
|
|
Heater not staked in mold |
| Replace mold and heater assembly |
|
| Apply alumilastic |
|
|
|
Broken locking tabs on vertical cam |
| Replace module |
|
|
|
| 6:00 Ejector Position | |
|
|
|
Contaminated |
| Replace mold and heater assembly |
|
| Apply alumilastic |
|
|
|
Insufficient water to ice maker, |
| Refer to “Hollow Ice Cubes” |
small or hollow cubes |
|
|
|
|
|
| 7:30 Ejector Position | |
|
|
|
Contaminated |
| Replace module |
Motor will not oscillate |
|
|
|
|
|
| Remove obstruction | |
obstructed |
| Replace module |
|
|
|
Cubes not formed properly |
| |
|
| Check fill cup and fill tube assembly |
|
|
|
| 9:00 Ejector Position | |
|
|
|
Contaminated |
| Replace module |
|
|
|
Cube frozen to fill cup or mold |
| |
|
| Replace fill cup and module |
|
|
|
RS1200001 | 48 | November 1996 |