7)Remove the bushings from hinge (C1) and hinge (C2) (the hinges attached to the door). See Fig. 9.
8)Remove the gasket from the door. See Fig. 10.
BushingGasket
Hinge
Fig. 9 | Fig. 10 |
9)Temporarily fasten the overlay panel to the door using 2 of the M4×25 pan head screws provided. See Fig. 11.
CAUTION
Ensure that the back surface of overlay panel is flat before attaching.
10)Mark the centerpoint of the hinge (C1) and hinge (C2) holes that extend over the overlay panel. See Fig. 12.
Screws |
Hinge
Door
Overlay Panel
Mark the center point.
Fig. 11 | Fig. 12 |
11)Remove the overlay panel from the door.
12)Drill 3/8" diameter holes 1/4" (7 mm) deep where you marked on the overlay panel to accommodate the hinge (C1) and hinge (C2) bushings.
17