Screws Top Panel Notch Hinge B Filler | Perlick H50IMW-AD, H50IMS-L

6)If you would like to reverse the door hinges, do the following:

a)Remove "hinge (A)-left" from the accessory bag.

b)Remove the 2 screws securing the top panel, then lift it off. See Fig. 4.

c)Remove hinge (A)-right and the bracket from the right side of the unit. Set aside hinge (A)‑right; it is not needed. Remove the top brace from the left side. Fasten hinge (A)-left and the bracket to the left side and the top brace to the right side. See Fig. 5.

Note: When on the proper side, the gasket notch for hinge (A) is to the inside.

	Screws	Bracket	Screw
Top Panel	Screws	Bracket
Top Panel
		Hinge (A)-Left

Gasket Notch

Fig. 4

Fig. 5

Screw

Top Brace

Hinge (A)-Right Not Needed

d)Remove hinge (B) from the right side of the unit and the 2 filler screws from the left side. Attach the 2 filler screws to the right side and attach hinge (B) to the left side. See Fig. 6.

e)Rotate the top panel 180° from its previous position. This brings the notch that was previously in the right rear to the left front. See Fig. 7. Hook the rear part of the panel on the body, then secure the front with the 2 screws removed in step 6a.

Screws

Top Panel

Notch

Hinge (B)

Filler

Screws

Fig. 6

Fig. 7

f)Remove hinge (C1) from the top right part of the door, flip it and reattach to the bottom left. Remove hinge (C2) from the bottom right part of the door, flip it and

reattach to the top left. See Fig. 8. Proceed to step 7.

Screws

Hinge (C2)

Fig. 8

Hinge (C1)

Screws