Before Operating

NE-1037

How to Operate

This oven is preset at the factory for the following:

To set the power level:

To set the cooking time:

Display:

Oven Light:

Make sure the oven is connected to a properly earthed electrical outlet.

When the door is closed, the display is still blank. When the door is opened, the display shows “0”. For the detailed operation, see the page on each feature.

1. Memory Pads preset to 1000 W at the indicated heating times for single stage heating.

Pad No.	1	2	3	4	5	6	7	8	9	0

Time	10 sec.	20 sec.	30 sec.	45 sec.	1 min.	1 min.	2 min.	2 min.	3 min.	3 min.
						30 sec.		30 sec.		30 sec.

The Double Quantity Pad (x2) preset to automatically double the programmed time of each Memory Pad. (See pages 12, 15)

Select power level before programming the cooking time.

Press
once	1000 W
twice	500 W
3 times...	340 W (Defrost)

You can set up to 30 minutes for and 99 minutes 99 seconds for and . Example 1: To set 15 minutes 45 seconds


Press	1	5		4		5

Example 2: To set 85 minutes 30 seconds
Press	8		5		3		0

When you press the Start Pad, the display shows 1 hour 25 minutes instead of 85 minutes 30 seconds. When selected cooking time is over an hour, the display shows hours and minutes, but the oven works for your setting time.

The display will go blank (when the door is closed):

●at more than 1 minute interruption.

●at more than 1 minute after completion of heating and removing food.

The display will flash “0”:

●continuously if the door is not opened to remove the food.

Example: Press

Program Unlock. (See page 16)

Cycle counter set to “0”. (See page 18)

Oven light will be turned on, when:

●the door is opened.

●heating starts.

Oven light will be turned off, when:

●the door is closed (no heating).

●heating finishes.

- 10 -