How to Operate
Programming
DO NOT OPEN THE DOOR
The display window MUST be blank before programming. If any indicator light is illuminated in the digital display window: close the door, press the Stop/Reset Pad and wait 1 minute until the display goes blank.
A. Programming Memory Pads for Single Stage Heating:
Example: To program 30 seconds at 500 W for Memory Pad 5
1. | • Press the Program Pad. |
| Note: |
•If no “ 
” Indicator appeared on display, “Program Lock” should be cancelled. (See page 16)
2. | 5 |
| • Press the Memory Pad 5. The pad |
| 1 |
|
|
| |||
|
|
| number and the previously selected time |
|
|
|
|
| and power level will appear in the display. |
| 1 |
|
|
|
|
| |
|
|
| • The pad number and Stage Heating |
| 1 |
|
|
|
|
| |
|
|
| Indicator will appear in the display again. |
|
|
3. |
|
| • Press the Power Level Pad twice. The |
| 1 |
|
|
|
| ||
|
|
| Memory Pad number will go out. |
|
|
4. |
|
| • Press Memory Pads 3 and 0. |
| 1 |
3 | 0 |
|
| ||
5. |
|
| • Press the Program Pad again. You have |
| 1 |
|
|
|
| ||
|
|
| completed programming the selected |
|
|
|
|
| Memory Pad for single stage heating. |
|
|
|
|
| Double heating time for double quantity |
|
|
|
|
| heating was automatically set. |
| 1 |
|
|
|
|
| |
|
|
| • 2 seconds later, the time and power level |
|
|
|
|
| setting you programmed will appear in | x2 | 1 |
|
|
| the display. | ||
|
|
|
|
| |
|
|
| • 2 seconds later, Double Quantity Heating | x2 | 1 |
|
|
|
|
| |
|
|
| Indicator and then the double heating |
|
|
|
|
| time will appear in the display. |
|
|
•2 seconds later, the display will go blank.
The Memory Pad 5 is now programmed for heating - 30 seconds at 500 W.
NOTE: • Program the remaining Memory Pads as desired by repeating steps 1 - 5. You may insert up to 10 memory programs.
•When the Program indicator “ 
” is blinking, the program can be cancelled and/or the pad number erased by pressing the Stop/Reset Pad.
NE-1037
- 13 -