TG654xBX(e).book Page 44 Tuesday, June 28, 2011 10:16 AM
Useful Information
Troubleshooting
If you still have difficulties after following the instructions in this section, disconnect the base unit’s AC adaptor, then reconnect the base unit’s AC adaptor. Remove the batteries from the handset, and then insert the batteries into the handset again.
General use
Problem | Cause/solution |
The handset does not turn | L Place the handset on the base unit or charger to |
on even after installing | turn on the handset. |
charged batteries. |
|
The unit does not work. | L Make sure the batteries are installed correctly |
| (page 8). |
| L Fully charge the batteries (page 8). |
| L Check the connections (page 8). |
| L Unplug the base unit’s AC adaptor to reset the |
| unit. Reconnect the adaptor and try again. |
| L The handset has not been registered to the base |
| unit. Register the handset (page 48). |
I cannot hear a dial tone. | L The base unit’s AC adaptor or telephone line cord |
| is not connected. Check the connections. |
| L Disconnect the base unit from the telephone line |
| and connect the line to a known working |
| telephone. If the working telephone operates |
| properly, contact our service personnel to have the |
| unit repaired. If the working telephone does not |
| operate properly, contact your service provider/ |
| telephone company. |
The indicator on the | L New messages have been recorded. Listen to the |
handset flashes slowly. | new messages (page 33). |
| L New voice mail messages have been recorded. |
| Listen to the new voice mail messages (page 38). |
|
|
Battery recharge |
|
|
|
Problem | Cause/solution |
The handset beeps and/or | L Battery charge is low. Fully charge the batteries |
d flashes. | (page 8). |
44
