Error messages | Panasonic KX-TG6542BX, KX-TG6541BX specs

TG654xBX(e).book Page 43 Tuesday, June 28, 2011 10:16 AM

Useful Information

Error messages

If the unit detects a problem, one of the following messages is shown on the display.

Display message	Cause/solution
Base no power	L The handset has lost communication with the
or	base unit. Move closer to the base unit and try
or	again.
No link. Re-connect	L Unplug the base unit’s AC adaptor to reset the
No link. Re-connect	unit. Reconnect the adaptor and try again.
base AC adaptor.	L The handset’s registration may have been
	canceled. Re-register the handset (page 48).
Busy	L The called unit is in use.
	L Other units are in use and the system is busy.
	Try again later.
	L The handset you are using is too far from the
	base unit. Move closer and try again.
Call phone company for	L You have not stored the voice mail access
your access #	number. Store the number (page 38).
Check tel line	L The supplied telephone line cord has not been
	connected yet or not connected properly.
	Check the connections (page 8).
Error!!	L Recording was too short. Try again.
Invalid	L There is no handset registered to the base
	unit matching the handset number you
	entered.
	L The handset is not registered to the base unit.
	Register the handset (page 48).
Requires subscription	L You must subscribe to a Caller ID service.
to Caller ID.	Once you receive caller information after
	subscribing to a Caller ID service, this
	message will not be displayed.
Use rechargeable	L A wrong type of battery such as Alkaline or
battery.	Manganese was inserted. Use only the
	rechargeable Ni-MH batteries noted on page
	4, 6.

43

Image 43

Panasonic KX-TG6542BX, KX-TG6541BX operating instructions Error messages, Display message Cause/solution

Contents

Before initial use, see Getting Started on Important Information Caller ID ServiceVoice Mail Service Introduction Model composition Accessory informationSupplied accessories Accessory item/Part number Quantity KX-TG6541 KX-TG6542 Accessory item Order number Additional/replacement accessories For your safety Important safety instructions Other information Connections Setting upBattery installation Battery charge Operation Operating time Intelligent eco modeDuring a power failure Battery level Icon OFF Flash Call Wait ControlsHandset Base unit Display Belt clip Dialing mode Initial settingsDate and time IPAUSE Using the base unitOFF Pause for PBX/long distance service users Erasing a number in the redial list Answering calls Useful features during a callUsing the handset Adjusting the base unit ringer volume For call waiting or Call Waiting Caller ID service usersRotary/pulse service users Flash Handset clarity booster Privacy modeCall share Adding entries PhonebookGroups Select Finding and calling a phonebook entryEditing entries Erasing entries Menu Chain dial Main menu Sub-menu Programmable settingsProgramming by scrolling through the display menus Menu Store VM access#*1 Feature Code Setting Programming using the direct commands For the answering system Feature Code Setting Min Greeting only Remote code Save AlarmNight mode Special programming Call block Caller ID Changing the handset nameSubscribers only Save iOFF To erase a number To edit a number Missed calls Using Caller ID serviceCaller ID features Talking Caller ID Group ringer tone for Caller listViewing the caller list Calling back Erasing all caller information Storing an area code to be deleted automaticallyEditing a caller’s phone number before calling back Erasing selected caller information Call screening Answering systemTurning the answering system on/off Memory capacity including your greeting message Greeting message Listening to messages using the base unit Pause Listening to messages using the handsetErasing all messages Operating the answering system Remote operation Voice memo Voice guidance Remote commandsTurning on the answering system remotely Selecting Greeting only Answering system settingsNumber of rings before the unit answers a call Caller’s recording time Message alert Listening to voice mail messages Voice mail serviceStoring the voice mail VM access number To erase the voice mail access number TG654xBXe.book Page 39 Tuesday, June 28, 2011 1016 AM Answering an intercom call IntercomHandset locator Making an intercom call Answering a transferred call Handset To establish a conference call Press Conf To stand on a desk Wall mountingCharger Hook Display message Cause/solution Error messages General use Problem Cause/solution TroubleshootingBattery recharge Problem Cause/solution Making/answering calls, intercom Problem Cause/solution Caller ID/Talking Caller ID Problem Cause/solution Liquid damage Problem Cause/solution Answering system Problem Cause/solution Deregistering a handset Registering a handset to the base unit Handset Index TG654xBXe.book Page 50 Tuesday, June 28, 2011 1016 AM TG654xBXe.book Page 51 Tuesday, June 28, 2011 1016 AM For your future reference PNQX5059ZA TC0711MG0Attach your purchase receipt here Copyright