Liebherr EWTN installation instructions Door Opening Angle Figures 14

Page 19

REVERSING DOOR HINGES

Door Opening Angle - Figures 14, 15

The appliance is delivered with a door opening angle of 130°.

If the angle is to be decreased to 90°, proceed as follows:

•Insert attached screw (6) in the upper hinge as shown in Figure 14.

•Insert attached screw (6) in the lower hinge as shown in Figure 15.

Figure 14

Figure 15

A delight in freshness

WFI1051 / EWTN 2956

17

Image 19

Contents Installation Instructions Please Read and Follow These Instructions To the Installer Table of Contents Installation Guidelines Planning Information Cabinet Opening Dimensions FigureWFI 1051 Figure Side-By-Side WFI 1051 RBI 1400 Figure Assembling Decorative Panels Framed Panels Figure Integrating CabinetryOverlay Panels single install Figure Overlay Panels side by side install 1219 Integrating Cabinetry Integrating Cabinetry Reversing Door Hinges LBR029 Reversing Door Hinges Door Opening Angle Figures 14 Unpacking InstallationSpanner Built-in appliances with a wooden ventilation grille Following ventilation cross-sectionDelight in freshness Blocking for Safety Icemaker Do not install the shut-off valve behind the applianceWater Connection Figure Solenoid valve is located at the rear of your unit Connection to the Water SupplySIDE-BY-SIDE Installation Installation with SBS Ventilation Grille Set Ca.210 Delight in freshness Push the long carriage bolt SIDE-BY-SIDE Installation 31 Connect the appliances Spanner SIDE-BY-SIDE Installation 13 mm 48 1219,2 mm 11/16 93,7 mm