INSTALLATION
-Figure 17: Connect the appliance to the main power supply.
-If the appliance is equipped with an IceMaker, establish the connection for the water supply. See “IceMaker, Water Connection”.
1
1
1.Carefully slide the appliance into the cabinet until the ventilation grille touches the surround- ing kitchen cabinet.
2.Align the appliance until it is parallel with the surrounding kitchen cabinet. Use the open- end wrench 10 mm (3) to adjust the feet at the front. Turn clockwise for up and counterclock- wise for down. For the rear use the adjusting
2
2 | 2 |
3 | 3 |
8 spanner
2
3
10 spanner
Figure 17
bolt (2). Turn clockwise for down and counter- clockwise for up.
Maximum adjustment: 19/64" (15 mm).
3. Figure 18: Align the appliance at the side with the cabinet side panel and attach it with screws (1).
- Cover the screws with cover caps (2).
4. Fit the ventilation grille at the bottom [(3) if the door is hinged on the left, (4) if it is on the right]: Secure the ventilation grille so that it touches the floor and then adjust it using the slots.
LBR036
Figure 18
A delight in freshness
WFI1051 / EWTN 2956 | 19 |