INSTALLATION
The following ventilation cross-section
and distances must be observed:
-There must be a ventilation space of at least 31 square inches (200 cm²) per appliance in the cabinet plinth and under the cabinet top panel.
-The depth of the ventilation duct at the rear of the cabinet must be at least
Alternatively:
1.For
•Figure 19:
-Screw the complete installation frame (2) to the appliance.
| 1 | 1/2” | |
38 |
| ||
( |
| mm) | |
|
| ||
At least 31 square inches (200cm2 )
|
|
| ” |
| |
|
| /4 |
| ) | |
| 3 |
| m | ||
0 |
|
| |||
2 |
|
| m |
| |
|
| 7 |
|
| |
| 2 |
|
|
| |
5 |
|
|
|
| |
( |
|
|
|
|
|
1
2
1
2.Built-in appliances with a wooden ventilation grille:
Figure 20: Cut out the wooden trim for use as a ventilation grille using the enclosed template.
-The required ventilation cross-sec- tion must be at least 31 square inches (200 cm²) when a single appliance is installed, which cor- responds to template “small” (If you install two appliances side-by-side, the cross-section must be at least
62 square inches, (400 cm²), which corresponds to template “double- size;” for more information see “Side-
•Remove the attachment bracket (2) from the installation frame and screw it to the appliance (1) from underneath. Place the wooden ventilation grille (5) on the appliance, align it in the center and secure it from the rear using the attachment bracket (2).
Figure 19
2 | 1/2" | |
5 | ||
(13 mm) | ||
1 |
| |
24" |
| |
(609,6 mm) | ||
| ||
(93,7 mm) |
| |
Figure 20
A delight in freshness
20 | WFI1051 / EWTN 2956 |