Liebherr EWTN installation instructions Planning Information, Cabinet Opening Dimensions Figure

Page 6

PLANNING INFORMATION

Cabinet Opening Dimensions - Figure 1

Allow units to open a minimum of 90° to prevent problems removing drawers. With the door open- ing 90°, you may have to move drawers slightly to clear the door interior.

Refer to the minimum door clearances in the Pre-

Installation Specifications chart.

• Allow for a minimum 3-3/4" (95 mm) filler, for corner installations, so the door can open to 90°. If you’re using raised panels, consider using a wider filler.

IMPORTANT

Refer to the full scale illustrations at the end of this section for specifics on door openings and filler size alternatives.

"

"

3"" (76mm)

"

" "

Figure 1

A delight in freshness

4

WFI1051 / EWTN 2956

Image 6
Contents Installation Instructions Please Read and Follow These Instructions To the Installer Table of Contents Installation Guidelines Cabinet Opening Dimensions Figure Planning InformationWFI 1051 Figure Side-By-Side WFI 1051 RBI 1400 Figure Assembling Decorative Panels Integrating Cabinetry Framed Panels FigureOverlay Panels single install Figure Overlay Panels side by side install 1219 Integrating Cabinetry Integrating Cabinetry Reversing Door Hinges LBR029 Reversing Door Hinges Door Opening Angle Figures 14 Installation UnpackingSpanner Following ventilation cross-section Built-in appliances with a wooden ventilation grilleDelight in freshness Blocking for Safety Do not install the shut-off valve behind the appliance IcemakerWater Connection Figure Connection to the Water Supply Solenoid valve is located at the rear of your unitSIDE-BY-SIDE Installation Installation with SBS Ventilation Grille Set Ca.210 Delight in freshness Push the long carriage bolt SIDE-BY-SIDE Installation 31 Connect the appliances Spanner SIDE-BY-SIDE Installation 13 mm 48 1219,2 mm 11/16 93,7 mm