Liebherr EWTN installation instructions SIDE-BY-SIDE Installation

Page 34

SIDE-BY-SIDE INSTALLATION

1.For built-in appliances without ventilation grilles and only with installation frame (2), ven- tilation must take place through the ventilation duct at the rear of the cabinet. Ensure that the ventilation cross-section is at least 31 square inches (200 cm²) per appliance.

At least 62 square inches (400 cm²) for side-by- side installation of two appliances. Built-in appli- ances with an installation frame:

-Figure 33: Screw the installation frame (2) to the appliance through the attachment brack- ets.

	1		1/2”
38
(		mm)

At least 31 square inches (200cm2) per unit

								”
							/4		)
						3			)
				0				m
				2				m
			”				7
			”			2
		/4			5
		/4		(
	3			)
0			m
2			m
		7
	2
5
(

1

2

Figure 33

A delight in freshness

32	WFI1051 / EWTN 2956

Image 34

Contents Installation Instructions Please Read and Follow These Instructions To the Installer Table of Contents Installation Guidelines Cabinet Opening Dimensions Figure Planning InformationWFI 1051 Figure Side-By-Side WFI 1051 RBI 1400 Figure Assembling Decorative Panels Integrating Cabinetry Framed Panels FigureOverlay Panels single install Figure Overlay Panels side by side install 1219 Integrating Cabinetry Integrating Cabinetry Reversing Door Hinges LBR029 Reversing Door Hinges Door Opening Angle Figures 14 Installation UnpackingSpanner Following ventilation cross-section Built-in appliances with a wooden ventilation grilleDelight in freshness Blocking for Safety Icemaker Do not install the shut-off valve behind the applianceWater Connection Figure Connection to the Water Supply Solenoid valve is located at the rear of your unitSIDE-BY-SIDE Installation Installation with SBS Ventilation Grille Set Ca.210 Delight in freshness Push the long carriage bolt SIDE-BY-SIDE Installation 31 Connect the appliances Spanner SIDE-BY-SIDE Installation 13 mm 48 1219,2 mm 11/16 93,7 mm