Rangemaster U109300 - 01 manual Positioning the Cooker, Unpacking the Cooker, Moving the Cooker

Page 25

INSTALLATION

Check the appliance is electrically safe and gas sound when you have finished.

Positioning the Cooker

The diagrams below show the minimum recommended distance from the cooker to nearby surfaces.

The cooker should not be placed on a base.

A clearance of 130mm is required if the cooker is near a corner of the kitchen to allow the oven doors to open. The actual opening of the doors is slightly less but this allows for some protection of your hand as you open the door.

The hotplate surround should be level with, or above, any adjacent work surface. Above hotplate level a gap of 75mm should be left between each side of the cooker and any adjacent vertical surface.

For non-combustible surfaces (such as unpainted metal or ceramic tiles) this can be reduced to 25mm.

A minimum space of 650mm is required between the top of the hotplate and a horizontal combustible surface.

*Any cooker hood should be installed in accordance with the hood manufacturer’s instructions.

Surfaces of furniture and walls at the sides and rear of the appliance should be heat, splash and steam resistant. Certain types of vinyl or laminate kitchen furniture are particularly prone to heat damage and discolouration. We cannot accept responsibility for damage caused

by normal use of the cooker to any material that de- laminates or discolours at temperatures less than 65°C above room temperature.

For safety reasons curtains must not be fitted immediately behind the cooker.

We recommend a gap of 910mm between units to allow for moving the cooker. Do not box the cooker in; it must be possible to move the cooker in and out for cleaning and servicing.

Unpacking the Cooker

Do not take any packaging off the cooker until it is directly in front of the place it is to be installed (unless it will not fit through a door in its outer packaging).

Cut the banding straps and lift the cardboard box off the cooker, leaving the cooker standing on the base packaging. See the loose unpacking sheet.

Moving the Cooker

The cooker is very heavy. Take great care.

We recommend two people manoeuvre the cooker. Ensure that the floor covering is firmly fixed, or removed to prevent it being disturbed when moving the cooker around. You will need the levelling tool.

From the back tilt the cooker forward and remove the rear half of the polystyrene base pack.

Repeat from the front and remove the front half of the polystyrene base.

LOWER THE TWO REAR ROLLERS.

First fit the levelling tool on the hexagonal adjusting nut as shown below.

25

Page 24 Page 26
Image 25
Page 24 Page 26
Contents Classic Deluxe Installation & Service Instructions U109300Be safe InstallationGas and Electricity on Peculiar smellsContents Gas burners Hotplate BurnersWok cradle Care and CleaningUse Only Dry Oven Gloves GriddleGlide-out Grill Using the grillLeft Hand Oven OvensClock Both Ovens Cooking using the timerTo activate the key lock To turn off the key lockRapid Response Multi-function oven functionsDefrost Fan ovenMain Oven shelve Right Hand OvenTall oven shelves HandyrackOven light Multi-function Oven cooking guide Cooking chart Fan assisted oven functionEnsure meat and poultry is fully cooked before serving Fish Oven Cooking chart Conventional and full Fan oven functionsHotplate burners Cleaning your cookerSingle ring burners Wok burner Control Panel and Doors GrillPart Finish Recommended Cleaning Method Cleaning Table HotplateOutside of cooker OvensMain Oven TroubleshootingOven temperature getting hotter as the cooker gets older Power failureHotplate ignition or hotplate burners faulty Food is cooking too slowly, too quickly, or burningIf you smell gas General Safety Instructions0800 111 Specification of this cooker should not be altered Dear Installer InstallationProvision of Ventilation Location of HotplateChecking the parts You will also need the following toolsUnpacking the Cooker Positioning the CookerMoving the Cooker Fit the Handles LevellingFitting the splash back optional Conversion to LPGas Connection Fitting a stability bracketElectrical Connection Pressure testingPressures Fitting the plinth Oven checkCustomer care Thank youConversion to LP gas Tap adjustmentInjectors To convert to LP gasStick on label Servicing ContentsTo Remove the Control Panel To Remove HotplateTo Change the Grill Controller To Change an Ignition Switch To Remove Light SwitchTo Remove Side Panels To Remove a ThermostatTo Change Hotplate Burner Injector To Adjust the Main Oven Door Catch KeepTo Change Hotplate Burner Electrode To Remove or Change a Hotplate BurnerTo Remove an Oven element Thermal Cut-Out To Change Tall Oven Door Outer PanelTo Remove Grill Element To Remove Oven Inner BackTop Element To Adjust the Oven Door AngleTo change oven light bulb Dimensions Technical DataThis cooker is category II2H3+ ConnectionsCode Circuit DiagramCode Colour Page 070606

U109300 - 01 specifications

The Rangemaster U109300-01 is a remarkable appliance designed to enhance cooking experiences in modern kitchens. This versatile range cooker blends functionality with aesthetic appeal, making it a popular choice for both amateur cooks and professional chefs.

One of the standout features of the U109300-01 is its dual fuel system. This technology combines the precision of gas cooking with the even heat distribution offered by electric ovens. Home chefs can enjoy the immediate heat response of gas burners on the cooktop alongside the consistent baking results delivered by the electric oven. This dual functionality not only optimizes cooking performance but also provides users with the flexibility to cook a wide variety of dishes with precision.

Another notable characteristic of this model is its spacious oven cavity. The Rangemaster U109300-01 boasts multiple cooking zones, allowing users to prepare multiple dishes simultaneously. It is equipped with multiple shelf positions and a generous capacity, making it ideal for meal prepping, baking, or entertaining guests.

In addition to its cooking power, the U109300-01 features advanced technologies designed to improve user experience and safety. The catalytic liners in the oven are specially designed to break down grease and food particles during cooking, making cleaning effortless. Furthermore, the appliance includes a flame failure device, which automatically shuts off the gas supply if a flame is not detected, ensuring safety in the kitchen.

The design of the Rangemaster U109300-01 is equally impressive. With its sleek finish and professional styling, it adds a touch of elegance to any kitchen decor. Available in a variety of colors, this range cooker can fit seamlessly into diverse kitchen aesthetics.

To enhance user convenience, the U109300-01 comes with a programmable timer and a range of cooking modes. Whether baking, roasting, grilling, or simmering, users can select the appropriate settings to achieve the best results.

In summary, the Rangemaster U109300-01 is a feature-rich range cooker that combines modern technology with a classic design. Its dual fuel system, spacious oven, advanced cleaning technologies, and safety features make it an essential addition to any kitchen, appealing to cooks of all skill levels who value performance and style.
Top Page Image Contents