Rangemaster U109300 - 01 manual Pressure testing, Electrical Connection, Pressures

Page 28

INSTALLATION

Check the appliance is electrically safe and gas sound when you have finished.

Although a 900mm hose can be used, a 1250mm hose will allow slightly more flexibility in the positioning of the bayonet and make moving the cooker easier. The hose should be fitted so that both inlet and outlet connections are vertical so that the hose hangs downwards.

The connector is located just below the hotplate level at the rear of the cooker.

For Natural Gas the flexible hose must be in accordance with B.S.669.

For LP Gas it should be capable of 50mbar pressure, 70°C temperature rise and carry a red stripe, band or label.

If in doubt contact, your supplier.

Screw connect the threaded end of the hose into the gas inlet in the underside of the connector block on the back of the cooker.

After completing the gas connection, check the cooker is gas sound with a pressure test.

Pressure testing

The gas pressure can be measured at one of the centre hotplate burner injectors (not the Wok burner). Lift off a burner head. Fit the pressure gauge to the injector. Turn on and light one of the other hotplate burners. Turn on the control knob for the burner with the pressure gauge fitted to let gas through.

Pressures

Natural Gas

LP Gas cookers

 

20mbar.

Butane

29mbar

 

Propane

37mbar

Turn off the burners. Reassemble burner top, making sure it is reassembled in the correct way on the burner body.

Electrical Connection

This appliance must be installed by a qualified electrician to comply with the relevant Institute of Electrical Engineers (I.E.E.) regulations and also the local electricity supply company requirements.

WARNING: THIS APPLIANCE MUST BE EARTHED

Note

The cooker must be connected to the correct electrical supply as stated on the voltage label on the cooker, through a suitable cooker control unit incorporating a double pole switch having a contact separation of at least 3mm in all poles. This cooker must not be connected to an ordinary domestic power point.

Single phase

Access to the mains terminal is gained by removing the electrical terminal cover on the back panel.

When preparing the electrical supply leads, make sure that the earth wire is longer that the phase or neutral wires. The earth lead should be long enough that it is never under any strain.

Connect the mains cable to the correct terminals for your electrical supply type (see fig.). Check that the links are correctly fitted and that the terminal screws are tight. Secure the mains cable using the cable clamp.

These appliances are of type X with regard to protection against over heating of the surrounding surfaces.

Current Operated Earth Leakage Breakers

Where the installation is protected by a 30 milliamp sensitivity residual current device (RCD), the combined use of your cooker and other domestic appliances may occasionally cause nuisance tripping. In these instances the cooker circuit may need to be protected by fitting 100mA device. This work should be carried out by a qualified electrician.

Hotplate

Check each burner in turn. There is an ignition system that works when the control knob is pressed in. Push in tap and turn to the large flame symbol.

Check that the burner lights correctly.

28

Page 27 Page 29
Image 28
Page 27 Page 29
Contents Installation & Service Instructions U109300 Classic DeluxeInstallation Be safeGas and Electricity on Peculiar smellsContents Hotplate Burners Gas burnersCare and Cleaning Wok cradleGriddle Use Only Dry Oven GlovesUsing the grill Glide-out GrillOvens Left Hand OvenClock Cooking using the timer Both OvensTo activate the key lock To turn off the key lockMulti-function oven functions Rapid ResponseDefrost Fan ovenRight Hand Oven Main Oven shelveTall oven shelves HandyrackOven light Multi-function Oven cooking guide Cooking chart Fan assisted oven functionEnsure meat and poultry is fully cooked before serving Oven Cooking chart Conventional and full Fan oven functions FishHotplate burners Cleaning your cookerSingle ring burners Wok burner Grill Control Panel and DoorsCleaning Table Hotplate Part Finish Recommended Cleaning MethodOutside of cooker OvensTroubleshooting Main OvenPower failure Oven temperature getting hotter as the cooker gets olderHotplate ignition or hotplate burners faulty Food is cooking too slowly, too quickly, or burningIf you smell gas General Safety Instructions0800 111 Specification of this cooker should not be altered Installation Dear InstallerProvision of Ventilation Location of HotplateYou will also need the following tools Checking the partsUnpacking the Cooker Positioning the CookerMoving the Cooker Levelling Fit the HandlesFitting the splash back optional Conversion to LPFitting a stability bracket Gas ConnectionElectrical Connection Pressure testingPressures Oven check Fitting the plinthCustomer care Thank youTap adjustment Conversion to LP gasInjectors To convert to LP gasStick on label Contents ServicingTo Remove the Control Panel To Remove HotplateTo Remove Light Switch To Change the Grill Controller To Change an Ignition SwitchTo Remove Side Panels To Remove a ThermostatTo Adjust the Main Oven Door Catch Keep To Change Hotplate Burner InjectorTo Change Hotplate Burner Electrode To Remove or Change a Hotplate BurnerTo Change Tall Oven Door Outer Panel To Remove an Oven element Thermal Cut-OutTo Remove Grill Element To Remove Oven Inner BackTop Element To Adjust the Oven Door AngleTo change oven light bulb Technical Data DimensionsThis cooker is category II2H3+ ConnectionsCode Circuit DiagramCode Colour Page 070606

U109300 - 01 specifications

The Rangemaster U109300-01 is a remarkable appliance designed to enhance cooking experiences in modern kitchens. This versatile range cooker blends functionality with aesthetic appeal, making it a popular choice for both amateur cooks and professional chefs.

One of the standout features of the U109300-01 is its dual fuel system. This technology combines the precision of gas cooking with the even heat distribution offered by electric ovens. Home chefs can enjoy the immediate heat response of gas burners on the cooktop alongside the consistent baking results delivered by the electric oven. This dual functionality not only optimizes cooking performance but also provides users with the flexibility to cook a wide variety of dishes with precision.

Another notable characteristic of this model is its spacious oven cavity. The Rangemaster U109300-01 boasts multiple cooking zones, allowing users to prepare multiple dishes simultaneously. It is equipped with multiple shelf positions and a generous capacity, making it ideal for meal prepping, baking, or entertaining guests.

In addition to its cooking power, the U109300-01 features advanced technologies designed to improve user experience and safety. The catalytic liners in the oven are specially designed to break down grease and food particles during cooking, making cleaning effortless. Furthermore, the appliance includes a flame failure device, which automatically shuts off the gas supply if a flame is not detected, ensuring safety in the kitchen.

The design of the Rangemaster U109300-01 is equally impressive. With its sleek finish and professional styling, it adds a touch of elegance to any kitchen decor. Available in a variety of colors, this range cooker can fit seamlessly into diverse kitchen aesthetics.

To enhance user convenience, the U109300-01 comes with a programmable timer and a range of cooking modes. Whether baking, roasting, grilling, or simmering, users can select the appropriate settings to achieve the best results.

In summary, the Rangemaster U109300-01 is a feature-rich range cooker that combines modern technology with a classic design. Its dual fuel system, spacious oven, advanced cleaning technologies, and safety features make it an essential addition to any kitchen, appealing to cooks of all skill levels who value performance and style.
Top Page Image Contents