Rangemaster U109300 - 01 manual Levelling, Fit the Handles, Fitting the splash back optional

Page 26

INSTALLATION

Check the appliance is electrically safe and gas sound when you have finished.

Make 10 complete (360º) turns clockwise. (This means turning and removing the levelling tool 20 times).

Make sure you lower BOTH REAR ROLLERS. There are two adjusting nuts, one for each roller, at both the front bottom corners of the cooker.

Unfold the rear edge of pack base tray. Open the grill door and the Tall oven door. Grip under the control panel and lift the front of the cooker.

Levelling

You are recommended to use a spirit level on a shelf in one of the ovens to check for level.

Place the cooker in its intended position taking care not to twist it within the gap between the kitchen units as damage may occur to the cooker or the units.

The rollers can be adjusted to level the cooker. To adjust the height of the rear of the cooker use the levelling tool supplied to turn the adjusting nuts at the front bottom corners of the cooker.

Adjust the height of the front roller to level the cooker. Turn clockwise to raise the cooker and anticlockwise to lower.

When you are satisfied with the height and level raise the front of the cooker by one turn of the front roller adjuster. Screw down the front feet to meet the floor. Screw the front roller adjuster anticlockwise to raise the front roller so that the front of the cooker is supported on the feet, not the front roller, to prevent accidental movement of the cooker.

Leave the levelling tool on the adjuster with the handle of the tool facing the rear of the cooker, so that the customer can use it if they wish to move the cooker.

Replace the drawer by locating on side runners and push in.

Fit the Handles

Remove the 4mm Allen screws from the doors with the hexagon key tool. Use the screws to fit the door handles.

The handles should be above the fixings.

Carefully push the cooker backwards off the pack base. Remove the pack base tray. Position the cooker close to

its final position leaving just

 

Remove the 4mm Allen screws from the top corners of the

 

fascia and fix the front handrail in position.

enough space to get behind

 

 

 

it.

 

 

Do not use the door handles or control knobs to

 

 

manoeuvre the cooker. Use the hotplate and griddle bowl

 

 

areas.

Fitting the splash back (optional)

 

Conversion to LP

 

Remove the two fixing screws (3mm hexagonal socket

 

head) and nuts that pass through the top of the rear flue

If the appliance is to be converted to LP gas do the

 

 

grille. Hold the splash back in position. From the rear refit

conversion at this point. See the conversion section of

the 2 fixing screws and nuts.

these instructions.

26

 

Page 25 Page 27
Image 26
Page 25 Page 27
Contents Installation & Service Instructions U109300 Classic DeluxeGas and Electricity on InstallationBe safe Peculiar smellsContents Hotplate Burners Gas burnersCare and Cleaning Wok cradleGriddle Use Only Dry Oven GlovesUsing the grill Glide-out GrillOvens Left Hand OvenClock To activate the key lock Cooking using the timerBoth Ovens To turn off the key lockDefrost Multi-function oven functionsRapid Response Fan ovenRight Hand Oven Main Oven shelveOven light HandyrackTall oven shelves Ensure meat and poultry is fully cooked before serving Cooking chart Fan assisted oven functionMulti-function Oven cooking guide Oven Cooking chart Conventional and full Fan oven functions FishSingle ring burners Wok burner Cleaning your cookerHotplate burners Grill Control Panel and DoorsOutside of cooker Cleaning Table HotplatePart Finish Recommended Cleaning Method OvensTroubleshooting Main OvenHotplate ignition or hotplate burners faulty Power failureOven temperature getting hotter as the cooker gets older Food is cooking too slowly, too quickly, or burning0800 111 General Safety InstructionsIf you smell gas Specification of this cooker should not be altered Provision of Ventilation InstallationDear Installer Location of HotplateYou will also need the following tools Checking the partsMoving the Cooker Positioning the CookerUnpacking the Cooker Fitting the splash back optional LevellingFit the Handles Conversion to LPFitting a stability bracket Gas ConnectionPressures Pressure testingElectrical Connection Customer care Oven checkFitting the plinth Thank youInjectors Tap adjustmentConversion to LP gas To convert to LP gasStick on label To Remove the Control Panel ContentsServicing To Remove HotplateTo Remove Side Panels To Remove Light SwitchTo Change the Grill Controller To Change an Ignition Switch To Remove a ThermostatTo Change Hotplate Burner Electrode To Adjust the Main Oven Door Catch KeepTo Change Hotplate Burner Injector To Remove or Change a Hotplate BurnerTo Remove Grill Element To Change Tall Oven Door Outer PanelTo Remove an Oven element Thermal Cut-Out To Remove Oven Inner BackTo change oven light bulb To Adjust the Oven Door AngleTop Element This cooker is category II2H3+ Technical DataDimensions ConnectionsCode Colour Circuit DiagramCode Page 070606

U109300 - 01 specifications

The Rangemaster U109300-01 is a remarkable appliance designed to enhance cooking experiences in modern kitchens. This versatile range cooker blends functionality with aesthetic appeal, making it a popular choice for both amateur cooks and professional chefs.

One of the standout features of the U109300-01 is its dual fuel system. This technology combines the precision of gas cooking with the even heat distribution offered by electric ovens. Home chefs can enjoy the immediate heat response of gas burners on the cooktop alongside the consistent baking results delivered by the electric oven. This dual functionality not only optimizes cooking performance but also provides users with the flexibility to cook a wide variety of dishes with precision.

Another notable characteristic of this model is its spacious oven cavity. The Rangemaster U109300-01 boasts multiple cooking zones, allowing users to prepare multiple dishes simultaneously. It is equipped with multiple shelf positions and a generous capacity, making it ideal for meal prepping, baking, or entertaining guests.

In addition to its cooking power, the U109300-01 features advanced technologies designed to improve user experience and safety. The catalytic liners in the oven are specially designed to break down grease and food particles during cooking, making cleaning effortless. Furthermore, the appliance includes a flame failure device, which automatically shuts off the gas supply if a flame is not detected, ensuring safety in the kitchen.

The design of the Rangemaster U109300-01 is equally impressive. With its sleek finish and professional styling, it adds a touch of elegance to any kitchen decor. Available in a variety of colors, this range cooker can fit seamlessly into diverse kitchen aesthetics.

To enhance user convenience, the U109300-01 comes with a programmable timer and a range of cooking modes. Whether baking, roasting, grilling, or simmering, users can select the appropriate settings to achieve the best results.

In summary, the Rangemaster U109300-01 is a feature-rich range cooker that combines modern technology with a classic design. Its dual fuel system, spacious oven, advanced cleaning technologies, and safety features make it an essential addition to any kitchen, appealing to cooks of all skill levels who value performance and style.
Top Page Image Contents