Rev. 0108
User Information, Cont’d
2.Scrub thoroughly, cleaning all surfaces, with soap and hot water.
3.Rinse with hot water, but do not flood.
4.Apply the sanitizing solution according to Hussmann’s directions.
5.Rinse thoroughly.
6.Dry completely before resuming operation.
CLEANING PRECAUTIONS
WHEN CLEANING:
•DO NOT WATER OVER 140° F
•DO NOT INTRODUCE WATER FASTER THAN WASTE OUTLET CAN DRAIN
•NEVER ON A SELF CONTAINED UNIT WITH AN EVAPORATOR FAN
•NEVER USE A CLEANING OR SANITIZING SOLUTION THAT HAS AN OIL BASE (these will dissolve the butyl sealants) or an AMMONIA BASE (this will corrode the copper components of the case)
TO PRESERVE THE ATTRACTIVE FINISH:
•DO USE WATER AND A MILD DETERGENT FOR THE EXTERIOR ONLY
•DO NOT USE ABRASIVES OR STEEL WOOL SCOURING PADS (these will mar the finish)
NOTE:
The evaporator pan must be monitored for
overflow conditions. Provide drainage if necessary.After cleaning and rinsing, purge the pan of any standing water.
•Care should be taken to minimize direct contact
between fan motors and cleaning or rinse water.
•Allow the merchandisers to dry before resuming operation.
•When cleaning lighted shelves, wipe down with a damp sponge or cloth so that water does not enter the light channel. Do NOT use a hose or submerge shelves in water.
CLEANING GLASS & MIRRORS
Only use a soft cloth and mild glass cleaner for cleaning any glass or mirrored components. Be sure to rinse and/ or dry completely.
Never use hot water on cold glass surfaces! It may shatter and cause serious injury! Allow glass
surfaces to warm first.
NON-GLARE GLASS
The high optical clarity of this glass is possible due to spe- cial coatings on the glass surface itself. To preserve this coating and the optical clarity, keep the glass clean.
Windex® or Glass Plus® are the only solutions recom- mended to be used to clean the
In addition to cleaning the glass with the recommended product, there are precautions that should be taken when working and cleaning the inside of the case.
•When cleaning the inside of the cases, we recom- mend that the glass be fully opened and covered to prevent solutions from splashing onto the glass and ruining the coating on the inside.
PLEXIGLASS & ACRYLIC CARE
Improper cleaning not only accelerates the cleaning cycle but also degrades the quality of this surface. Normal daily buffing motions can generated static cling attracting dust to the surface. Incorrect cleaning agents or cleaning cloths can cause micro scratching of the surface,causing the plastic to haze over time.
CLEANING
Hussmann recommends using a clean damp chamois, , or a paper towel marked as dust and abrasive free with 210® Plastic Cleaner and Polish available by calling Sumner Labs at
ANTISTATIC COATINGS
The 210® has proven to be very effective in not only clean- ing and polishing the Plexiglass surface, but also providing
13