John Lewis JLDWS1202 Starting a Dishwashing Cycle, Interrupting or Cancelling a Dishwashing Cycle

Page 22

Starting a Dishwashing Cycle

1.Check that the spray arms can turn freely.

2.Turn the water tap on fully.

3.Press the ON/OFF button.

4.Select the desired cycle.

The programme indicator comes on. The remaining time expected for the cycle will be shown in the multi-display.

3 During the dishwashing cycle, the remaining time shown in the multi- display may be adjusted according to the size of the load, degree of soiling, etc.

5.Close the door. The dishwashing cycle will begin.

A light signal in the form of a dot appears at floor level.

3 If the dishwasher is built in at high level with flush fitting cupboard doors around it, the light signal cannot be seen.

The dot shaped light signal is not dangerous. (It is not a laser.) It lights up while a dishwasher cycle is running and goes out when the cycle ends.

Interrupting or Cancelling a Dishwashing Cycle

Only interrupt a dishwashing cycle that is in progress if it is absolutely necessary.

Interrupting the dishwashing programme by opening the dishwash- er door

1 Hot steam may escape when the door is opened. There is a risk of scald- ing.

1.Open the door carefully. The dishwashing cycle will stop.

2.Close the door. The cycle will continue.

Cancelling the dishwashing cycle

1.Press function buttons 2 and 3 and keep them pressed.

The LED indicators of all the buttons that can be selected light up. Exception: The 3in1 button will only illuminate if the function has been activated.

2.Release the function buttons. The dishwashing cycle has been can- celled.

3.If you want to start a new cycle, check whether there is any detergent in the dispenser.

4.Switch off using the ON/OFF button.

22

Image 22
Contents JLDWS1202 Following symbols are used in the text Dear CustomerContents Child Safety SafetyPrior to using for the first time Follow the Instructions for installation and connectionGeneral Safety Diagram of Appliance Control PanelFunction button Setting manually Prior to Using for the First TimeSetting the Water Softener Setting electronically10L Only when using the dishwasher for the first time Adding Dishwasher SaltFilling Up with Rinse Aid Setting the Amount of Rinse Aid Required Activating/Deactivating the Rinse Aid dispenserActivating/Deactivating the Acoustic Signal Daily Use Loading Cutlery and DishesLoading cutlery Cups, Glasses, Coffee Service Pots, Pans, Large PlatesPage Adjusting the Height of the Upper Basket Raising/Lowering the Upper Bas- ketAdding Detergent Concentrated detergents Using 3in1 DetergentsDetergent tablets Selecting the Dishwashing Cycle Cycle Table Dishwashing Suitable TypeCancelling the dishwashing cycle Interrupting or Cancelling a Dishwashing CycleStarting a Dishwashing Cycle Cancelling the time delay Setting the Delay TimerTo change the time delay To change a dishwashing cycleSwitching Off the Dishwasher Care and CleaningRemoving the Dishes Cleaning the Filters Reinsert the flat filterWhat to do if Remedying Small MalfunctionsMalfunction Possible cause Remedy Short warning tones Dishes do not dry and are not shining If the Dishwashing Results are not SatisfactoryDishes are still dirty There are dried water drops on the glasses and dishesPackaging material Technical DataDisposal Old applianceSample loading arrangements Full load Half loadPage Installation and Connection Instructions Safety Information for the InstallationInstalling the Dishwasher Free-standing appliances Connecting the inlet hose Connecting the DishwasherConnecting to the water supply Permitted water pressureWater drainage Anti-flood systemChanging a fuse Electrical ConnectionGreen and Yellow Earth BlueNeutral BrownLive Connecting systems Service and Spare Parts 0870 01Subject to change without notice