John Lewis JLDWS1202 instruction manual 10L

3 If the LED indicator of only one programme button is illuminated, this wash programme has been activated. The wash programme must be deselected:

Press function buttons 2 and 3 simultaneously for approx. 2 seconds. The LED indicators of all the buttons that can be selected will illumi- nate.

Exception: The 3in1 button will only illuminate if the function has been activated.

2.Press function buttons 2 and 3 simultaneously and hold them down. The LED indicators for function buttons 1 to 3 will flash.

3.Press function button 1.

The LED indicator for function button 1 will flash. The multi-display will indicate the hardness setting.

4.Pressing function button 1 increases the hardness setting by 1. (Exception: hardness setting 1 follows hardness setting 10).

5.When the hardness setting is correct, press the ON/OFF button. The hardness setting is now saved.

If the water softener is set electronically to “1”, this switches off the control indicator for dishwasher salt.

Water hardness			Setting for		Indicator	Number
			water hardness
						of
					on the multi-
in	in					acoustic
		Range	Manual	Electronic	display	signals	1)
°d 2)	mmol/l 3)
51 - 70	9.0 - 12.5			10 4)	10L	10
43 - 50	7.6 - 8.9			9	9L	9
37 - 42	6.5 - 7.5	IV	1	8	8L	8
29 - 36	5.1 - 6.4			7	7L	7
23 - 28	4.0 - 5.0			6	6L	6
19 - 22	3.3 - 3.9	III		5	5L	5
15 - 18	2.6 - 3.2			4*	4L	4
11 - 14	1.9 - 2.5	II	0*	3	3L	3
4 - 10	0.7 - 1.8	I/II		2	2L	2
below 4	below 0.7	I		1		1
				no salt	1L
				required

1)The water hardness will only be indicated acoustically if the acoustic signal has been activated.

2)(°d) German degree, measure of the hardness of water

3)[mmol/l] millimol per litre, international unit for water hardness

4)On this setting the length of the dishwashing cycle may be slightly longer.

*) factory setting

9