John Lewis JLDWS1202 instruction manual Electrical Connection, Changing a fuse

Page 37

Electrical Connection

Any electrical work required to install this appliance should be car- ried out by a qualified electrician or competent person.

1 WARNING - This appliance must be earthed.

The manufacturer declines any responsibility should these safety measures not be observed.

Before switching on make sure the electricity supply voltage is the same as that indicated on the appliance rating plate.

To isolate the dishwasher from the mains, remove the mains plug. Important: The plug must still be accessible after the appliance has been installed.

Changing a fuse

The appliance is supplied with a 13amp plug fitted. In the event of hav- ing to change the fuse in the plug supplied, a 13amp ASTA approved (BS 1363A) fuse must be used.

Should the plug need to be replaced for any reason, proceed as described below.

The wires on the mains lead are col- oured in accordance with the fol- lowing code.

Green & Yellow

Green and Yellow: Earth

Blue:Neutral

Brown:Live

Blue

Brown

Cord Clamp

The wire coloured green and yellow must be connected to the termi-

nal marked with the letter “E“ or by the earth symbol or coloured green and yellow.

The wire coloured blue must be connected to the terminal “N“ or col- oured black.

The wire coloured brown must be connected to the terminal marked “L“ or coloured red.

Upon completion there must be no cut, or stray strands of wire present and the cord clamp must be secure over the outer sheath.

1WARNING! A cut off plug inserted into a 13 amp socket is a seri- ous safety (shock) hazard. Ensure that, if it is necessary to cut off the plug, it is disposed of safely and not retained.

37

Image 37
Contents JLDWS1202 Dear Customer Following symbols are used in the textContents Prior to using for the first time SafetyChild Safety Follow the Instructions for installation and connectionGeneral Safety Control Panel Diagram of ApplianceFunction button Setting the Water Softener Prior to Using for the First TimeSetting manually Setting electronically10L Adding Dishwasher Salt Only when using the dishwasher for the first timeFilling Up with Rinse Aid Activating/Deactivating the Rinse Aid dispenser Setting the Amount of Rinse Aid RequiredActivating/Deactivating the Acoustic Signal Loading Cutlery and Dishes Daily UseLoading cutlery Pots, Pans, Large Plates Cups, Glasses, Coffee ServicePage Raising/Lowering the Upper Bas- ket Adjusting the Height of the Upper BasketAdding Detergent Concentrated detergents Using 3in1 DetergentsDetergent tablets Dishwashing Suitable Type Selecting the Dishwashing Cycle Cycle TableCancelling the dishwashing cycle Interrupting or Cancelling a Dishwashing CycleStarting a Dishwashing Cycle To change the time delay Setting the Delay TimerCancelling the time delay To change a dishwashing cycleSwitching Off the Dishwasher Care and CleaningRemoving the Dishes Reinsert the flat filter Cleaning the FiltersRemedying Small Malfunctions What to do ifMalfunction Possible cause Remedy Short warning tones Dishes are still dirty If the Dishwashing Results are not SatisfactoryDishes do not dry and are not shining There are dried water drops on the glasses and dishesDisposal Technical DataPackaging material Old applianceFull load Half load Sample loading arrangementsPage Safety Information for the Installation Installation and Connection InstructionsInstalling the Dishwasher Free-standing appliances Connecting to the water supply Connecting the DishwasherConnecting the inlet hose Permitted water pressureAnti-flood system Water drainageChanging a fuse Electrical ConnectionGreen and Yellow Earth BlueNeutral BrownLive Connecting systems 0870 01 Service and Spare PartsSubject to change without notice