John Lewis JLDWS1202 instruction manual What to do if, Remedying Small Malfunctions

What to do if...

Remedying Small Malfunctions

In the event of a fault, the light signal at floor level flashes.

If the acoustic signal is activated, warning tones sound if there are faults.

If one of the following fault codes is displayed in the multi-display dur- ing operation:

–Fault codeÅ 10 (Problems with water inlet),

–Fault codeÅ 20 (Problems with water drainage), please have a look at the following table.

When the fault is remedied, press the button for the cycle that has started. The cycle will continue.

With other fault codes (“Å ” followed by a number):

–Cancel the dishwashing cycle.

–Switch the appliance off and on again.

–Re-set the dishwashing cycle.

If the fault is displayed again, please contact your local Service Force Centre and inform them of the fault code.

Malfunction	Possible cause	Remedy
	Water tap is blocked with	Check the water tap and
	limescale or faulty.	have it repaired if necessary.
	The tap is turned off.	Turn the tap on.
1 short warning tone	The filter (where present) in	Clean the filter in the
continuously repeated can	the threaded hose fitting	threaded hose fitting.
be heard,	on the tap is blocked.
the cycle indicator for the		Press the button for the
selected dishwashing cycle
		commenced dishwashing
is flashing:
		cycle;
fault code Å 10 is dis-	Filters in the base of the
		then cancel the dishwashing
played in the multi-dis-	dishwasher compartment
		cycle (see section: Starting a
play:	are blocked.
		dishwashing cycle);
(Problems with water in-
		clean filters (see section:
let)
		Cleaning the filters).
	Water inlet hose	Check the position of the
	has not been correctly posi-
	tioned.	hose.

26