John Lewis JLDWS1202 instruction manual Installation and Connection Instructions

Page 32

Installation and Connection Instructions

1Safety Information for the Installation

•Only transport the dishwasher in an upright position, otherwise salt water may run out.

•Before using the dishwasher for the first time, check for any damage caused in transport. Do not under any circumstances connect an ap- pliance that is damaged. In the case of damage, please contact your supplier.

•Never use the dishwasher if the mains cable, water inlet or drain hose are damaged; or if the control panel, work top or plinth area are damaged such that the inside of the appliance is freely accessible.

•Always plug the mains plug into a correctly installed shockproof socket.

•Permanent connection: a permanent connection must only be in- stalled by a trained electrician.

•Prior to using the appliance for the first time, ensure that the rated voltage and type of supply on the rating plate match that of the sup- ply where the appliance is to be installed. The fuse rating is also to be found on the rating plate.

•Multi-way plugs / connectors and extension cables must not be used. This could constitute a fire hazard through overheating.

•The dishwasher’s cable must only be replaced by a Service Force Engi- neer.

•A water inlet hose with safety valve must only be replaced by a Serv- ice Force Engineer.

•This appliance is heavy.

Care should be taken when moving it.

32

Image 32

Contents JLDWS1202 Following symbols are used in the text Dear CustomerContents Safety Prior to using for the first timeChild Safety Follow the Instructions for installation and connectionGeneral Safety Diagram of Appliance Control PanelFunction button Prior to Using for the First Time Setting the Water SoftenerSetting manually Setting electronically10L Only when using the dishwasher for the first time Adding Dishwasher SaltFilling Up with Rinse Aid Setting the Amount of Rinse Aid Required Activating/Deactivating the Rinse Aid dispenserActivating/Deactivating the Acoustic Signal Daily Use Loading Cutlery and DishesLoading cutlery Cups, Glasses, Coffee Service Pots, Pans, Large PlatesPage Adjusting the Height of the Upper Basket Raising/Lowering the Upper Bas- ketAdding Detergent Detergent tablets Using 3in1 DetergentsConcentrated detergents Selecting the Dishwashing Cycle Cycle Table Dishwashing Suitable TypeStarting a Dishwashing Cycle Interrupting or Cancelling a Dishwashing CycleCancelling the dishwashing cycle Setting the Delay Timer To change the time delayCancelling the time delay To change a dishwashing cycleRemoving the Dishes Care and CleaningSwitching Off the Dishwasher Cleaning the Filters Reinsert the flat filterWhat to do if Remedying Small MalfunctionsMalfunction Possible cause Remedy Short warning tones If the Dishwashing Results are not Satisfactory Dishes are still dirtyDishes do not dry and are not shining There are dried water drops on the glasses and dishesTechnical Data DisposalPackaging material Old applianceSample loading arrangements Full load Half loadPage Installation and Connection Instructions Safety Information for the InstallationInstalling the Dishwasher Free-standing appliances Connecting the Dishwasher Connecting to the water supplyConnecting the inlet hose Permitted water pressureWater drainage Anti-flood systemGreen and Yellow Earth BlueNeutral BrownLive Electrical ConnectionChanging a fuse Connecting systems Service and Spare Parts 0870 01Subject to change without notice