John Lewis JLDWS1202 instruction manual Setting the Amount of Rinse Aid Required

Page 12

Setting the Amount of Rinse Aid Required

3 Only change the amount dispensed, if smears, milky spots (reduce the amount) or dried on water spots (increase the amount) can be seen on glasses and dishes. (See section “If dishwashing results are not satisfac- tory”.) The dosage can be set from 1-6. The dosage is pre-set to “4” in the factory.

1.Open the dishwasher door.

2.Press the release button on the rinse

aid compartment.

3. Open the cover.

4.Set the dosage level.

5. Press the lid shut until it clicks into place.

6. If rinse aid has leaked out, wipe it away with a cloth.

Activating/Deactivating the Rinse Aid dispenser

If the 3 in1 button is pressed, you do not need to deactivate the rinse aid dispenser.

1.Press the ON/OFF button.

3 If the LED indicator of only one programme button is illuminated, this wash programme has been activated. The wash programme must be deselected:

Press function buttons 2 and 3 simultaneously for approx. 2 seconds. The LED indicators of all the buttons that can be selected will illumi- nate.

Exception: The 3in1 button will only illuminate if the function has been activated.

2.Press function buttons 2 and 3 simultaneously and hold them down. The LED indicators for function buttons 1 to 3 will flash.

3.Press function button 2.

The LED indicator for function button 2 will flash. The multi-display will indicate the current setting:

0d	Rinse aid dispenser is deactivated
1d	Rinse aid dispenser is activated (factory setting)

12

Image 12

Contents JLDWS1202 Following symbols are used in the text Dear CustomerContents Safety Prior to using for the first timeChild Safety Follow the Instructions for installation and connectionGeneral Safety Diagram of Appliance Control PanelFunction button Prior to Using for the First Time Setting the Water SoftenerSetting manually Setting electronically10L Only when using the dishwasher for the first time Adding Dishwasher SaltFilling Up with Rinse Aid Setting the Amount of Rinse Aid Required Activating/Deactivating the Rinse Aid dispenserActivating/Deactivating the Acoustic Signal Daily Use Loading Cutlery and DishesLoading cutlery Cups, Glasses, Coffee Service Pots, Pans, Large PlatesPage Adjusting the Height of the Upper Basket Raising/Lowering the Upper Bas- ketAdding Detergent Using 3in1 Detergents Concentrated detergentsDetergent tablets Selecting the Dishwashing Cycle Cycle Table Dishwashing Suitable TypeInterrupting or Cancelling a Dishwashing Cycle Cancelling the dishwashing cycleStarting a Dishwashing Cycle Setting the Delay Timer To change the time delayCancelling the time delay To change a dishwashing cycleCare and Cleaning Switching Off the DishwasherRemoving the Dishes Cleaning the Filters Reinsert the flat filterWhat to do if Remedying Small MalfunctionsMalfunction Possible cause Remedy Short warning tones If the Dishwashing Results are not Satisfactory Dishes are still dirtyDishes do not dry and are not shining There are dried water drops on the glasses and dishesTechnical Data DisposalPackaging material Old applianceSample loading arrangements Full load Half loadPage Installation and Connection Instructions Safety Information for the InstallationInstalling the Dishwasher Free-standing appliances Connecting the Dishwasher Connecting to the water supplyConnecting the inlet hose Permitted water pressureWater drainage Anti-flood systemElectrical Connection Changing a fuseGreen and Yellow Earth BlueNeutral BrownLive Connecting systems Service and Spare Parts 0870 01Subject to change without notice