Master Bilt CMICL-156 manual MASTER-BILT Part Numbers, Sale and Disposal, Owner Responsibility

Page 14

6.Compressor will not start – hums, but cycles on overload

A.Low voltage.

B.Relay defective.

C.Overload defective.

D.High head pressure (see 1).

7.Special service situations

If moisture or liquid is observed around or under a Master-Bilt cabinet, an immediate investigation should be made by qualified personnel to determine the source of moisture or liquid. The investigation made should determine if the cabinet is malfunctioning or if there is a simple housekeeping problem.

Moisture or liquid around or under a cabinet is a potential slip/fall hazard for persons walking by or working in the general area of the cabinet.

Any cabinet malfunction or housekeeping problem that creates a slip/fall hazard around or under a cabinet should be corrected immediately.

MASTER-BILT PART NUMBERS

The table below gives Master-Bilt part numbers. Use this chart when ordering replacement parts for your CM/CM cases.

Description

CM/CL-156

Qty

 

R35E-070UU

1

SK#3 & 3A

R35XZ070UU

1

SK # 1

C12X-070UU

4

SK # 1

W46X-070UU

3

28X63-RH-NSF-1092-DGT-SK#2-2P-

D28RX070UU

1

 

F35E-07-UU

1

 

F35S-070UU

1

TOTALS

 

12

 

 

 

Vapor Proof Light Globe(for door panel)

23-00594

1

1 " Dia. Gray Plug Buttons

29-01287

70

1 " Dia. Chrome Plug Buttons

29-01300

8

5/16" Hex Cam Wrench

35-0180

1

 

 

 

SALE AND DISPOSAL

OWNER RESPONSIBILITY

If you sell or give away your Master-Bilt cabinet you must make sure that all safety labels and the Installation- Service Manual are included with it. If you need replacement labels or manuals, Master-Bilt will provide them free. Contact the customer service department at Master-Bilt at (800) 684-8988.

The customer service department at Master-Bilt should be contacted at the time of sale or disposal of your cabinet so records may be kept of its new location.

If you sell or give away your Master-Bilt cabinet and you evacuate the refrigerant charge before shipment, Master-Bilt recommends that the refrigerant charge be properly recovered in compliance with section 608 of the Clean Air Act effective November 1995 and in accordance with all applicable local, regional, or national standards.

14

Image 14
Contents Installation & Operations Manual Page Table of Contents Introduction Store ConditionsGround Required For Safe Operation Inspection for Shipping Damage PRE-INSTALLATION InstructionsInstallation Instructions General InstructionsElectrical Panel StorageCAM Fasteners Figure #3Level Floor CaulkingDoor and Frame Installation Floor AssemblyCeiling and Wall Panel Assembly Adjusting Door and Replacing Hinges RefrigerationDoor Frame Heater Replacement Temperature ControlsFinal Check List Set three 30 minutes per 24 hoursOwner Responsibility MASTER-BILT Part NumbersSale and Disposal Page Page Page Page