Master Bilt CMICL-156 manual Ground Required For Safe Operation

Page 5

WARNING LABELS AND SAFETY INSTRUCTIONS

This symbol is the safety-alert symbol. When you see this symbol on your cabinet or in this manual be alert to the potential for personal injury or damage to your equipment.

Be sure you understand all safety messages and always follow recommended precautions and safe operating practices.

NOTICE TO EMPLOYERS

You must make sure that everyone, who installs, uses or services your cabinet is thoroughly familiar with all safety information and procedures.

Important safety information is presented in this section and throughout this section and throughout the manual. The following signal words are used in the warnings and safety messages:

DANGER: Severe injury or death will occur if you ignore the message.

WARNING: Severe injury or death can occur if you ignore the message.

CAUTION: Minor injury or damage to your cabinet can occur if you ignore the message.

NOTICE: This is important installation, operation or service information. If you ignore the message, you may damage your cabinet.

The warning and safety labels shown throughout this manual are placed on your Master-Bilt Products cabinet at the factory. Follow all warning label instructions. If any warning or safety labels become lost or damaged, call your customer service department at (800) 684-8988 for replacements.

This label is attached to the cabinet power cord label and on the wiring channel.

CAUTION!

GROUND REQUIRED

FOR SAFE OPERATION

This label is located on top of the electrical control on models with a power cord

.

5

Image 5
Contents Installation & Operations Manual Page Table of Contents Store Conditions IntroductionGround Required For Safe Operation Installation Instructions PRE-INSTALLATION InstructionsInspection for Shipping Damage General InstructionsPanel Storage ElectricalFigure #3 CAM FastenersCaulking Level FloorDoor and Frame Installation Floor AssemblyCeiling and Wall Panel Assembly Refrigeration Adjusting Door and Replacing HingesTemperature Controls Door Frame Heater ReplacementSet three 30 minutes per 24 hours Final Check ListOwner Responsibility MASTER-BILT Part NumbersSale and Disposal Page Page Page Page