GEAppliances.ca
The oven door must be closed and all controls set correctly for the cycle to work properly.
Safety
How to Delay the Start of Cleaning
You can set the oven control to
Make sure the clock shows the correct time of day.
Follow the directions in the Before a Clean Cycle section.
Latch the door.
NOTE: Never force the latch. If the oven is too hot, you will not be able to slide the latch. Allow the oven to cool.
Touch the CLEAN pad.
Touch the + or – pads to set the Clean Time.
The Clean Time is preset for 4 hours and 20 minutes. You can change the Clean Time to any time between 3 and 5 hours, depending on the amount of soil in your oven. If a different Clean Time is desired, touch the + or – pads until the desired Clean Time is displayed.
Touch the START TIME pad.
Change the Start Time by touching the + or – pads. The start time will appear in the display.
Touch the START/ON pad.
The
While the oven is
The oven shuts off automatically when the clean cycle is complete, and 0:00 will flash in the display.
Slide the latch handle to the left as far as it will go and open the door.
Instructions Operating Instructions Care and
To Stop a Clean Cycle
Touch the OFF pad.
Wait until the oven has cooled below
the locking temperature to unlatch the door. You will not be able to open the door right away unless the oven has cooled below the locking temperature.
Cleaning Troubleshooting
After a Clean Cycle
You may notice some white ash in the oven. Wipe it up with a damp cloth after the oven cools.
If white spots remain, remove them with a
These deposits are usually a salt residue that cannot be removed by the clean cycle.
If the oven is not clean after one clean cycle, repeat the cycle.
■You cannot set the oven for cooking until the oven is cool enough for the door
to unlock.
■While the oven is
■If the racks become hard to slide, apply a small amount of vegetable oil or cooking oil to a paper towel and wipe the edges of the oven racks with
the paper towel.
Tips Consumer Support
23